ANALYSIS OF WEAR AND TEAR OF WORKING ELEMENTS WITH A REPLACEABLE CUTTING EDGE IN AN ABRASIVE SOIL MASS
Journal Title: Tribologia - Year 2017, Vol 273, Issue 3
Abstract
This paper presents an analysis of the wear and tear process of different technological solutions of plough blades with a replaceable cutting edge. The experiment was conducted under natural operating conditions. Workpieces made of B27, Hardox 500, and Hardox 500 with padding weld, and two types of boron steel with non-hardfaced and hardfaced cutting edges were tested. The analyses of chemical composition and microstructure were performed using light microscopy and scanning electron microscopy methods. Operational research included the measurement of mass changes and geometry in the characteristic points of the plough blades. Based on the results obtained, it was found that the components made of Hardox 500 steel with padding welding were more durable than component without the padding layer. In contrast, the weight loss intensity was similar for all the examined materials.
Authors and Affiliations
Magdalena LEMECHA, Jerzy NAPIÓRKOWSKI, Łukasz KONAT
Keywords
Related Articles
- EP ID EP239472
- DOI -
- Views 87
- Downloads 0
WŁAŚCIWOŚCI MECHANICZNE POWŁOK PVD OSADZANYCH NA AZOTOWANYM STOPIE CoCrMo
Artykuł dotyczy oceny mechanicznych właściwości kompozytu warstwa azotowana/powłoka PVD utworzonego na stopie ortopedycznym CoCrMo stosowanym w aplikacjach biotribologicznych. Przeprowadzono optymalizację procesu azotowa...
DYNAMIC MODELS OF FRICTION IN THE ANALYSES OF THE TANGENTIAL CONTACT VIBRATION EFFECT ON FRICTION FORCES IN SLIDING MOTION
The explanation of driving force reduction in sliding motion under the influence of longitudinal tangential contact vibrations demands the adequate analyses of friction force changes caused by these vibrations. The resul...
THE INFLUENCE OF THE ADDITION OF GRAPHITE ON THE TRIBOLOGICAL PROPERTIES OF POLYLACTIC (PLA) APPLIED IN 3D PRINTING TECHNOLOGY
The article presents the results of studies on the influence of the addition of graphite to a PLA filament on linear wear and the coefficient of friction. A cylinder of 8 millimetre diameter manufactured in Fused Filamen...
PROPOSED METHOD FOR DETERMINING THE VALUES OF TESTS FOR THE BALL-CRATERING METHOD
The presented three-stage method of test parameter selection for the ball-cratering method allows one to determine the working conditions leading to wear scars with highly regular shape. Based on aforementioned regular w...
THE IMPACT ANALYSIS OF THE EXPERIMENTAL PLAN ON THE MODEL OF ANTI-WEAR PROPERTIES
The article presented the results of analysis of models of the wear limiting load capacity that were developed based on the experimental data. The elements of friction contacts lubricated with mineral oil with additives...