APPLICATION OF HIGH VOLTAGE DIVIDERS FOR POWER QUALITY INDICES MEASUREMENT
Journal Title: Електротехніка і Електромеханіка - Year 2017, Vol 0, Issue 6
Abstract
Introduction. Determination of power quality indices in high-voltage power grids allows to find the reasons for the deterioration of the power quality. The relevant national and International Standards for power quality contain relevant norms of quality indices and requirements for their accuracy measurement. Problem. The most complicated part in the process of measuring the power quality indices at high voltage is the selection of the corresponding high-voltage scale voltage converters. Therefore, comparing the requirements of IEC 61000-4-30 to high voltage scale voltage converters is an important task. Goal. Analysis of the International Standard IEC 61000-4-30 requirements feasibility for measuring the indices of power quality in high-voltage electrical networks using different types of high-voltage scale voltage converters. Methodology. Comparison of the requirements of IEC 61000-4-30 Standard to high-voltage scale voltage converters, when measuring power quality indices, with the characteristics of high voltage electromagnetic transformers used in Ukraine, and with promising developments of high-voltage converters of other types. Results. It is shown in the study that in order to fulfill some of the requirements for class A of IEC 61000-4-30, the characteristics of electromagnetic voltage transformers should be determined in the substation conditions using mobile calibration high-voltage laboratories. To meet all the requirements for Class A IEC 61000-4-30, it is recommended to use broadband high-voltage dividers of resistive-capacitive type. Originality. In study it is shown firstly that all the requirements of the IEC 61000-4-30 Standard for high-voltage scale voltage converters can be performed on the basis of the use of broadband resistive-capacitive damped voltage dividers. Practical value. Expositions of specific types of resistive-capacitive high-voltage dividers are presented, their parameters are confirmed by the results of state metrological certification.
Authors and Affiliations
Y. L. Anokhin, V. O. Brzhezytskyi, Ya. O. Haran, I. M. Masliuchenko, O. P. Protsenko, Ye. O. Trotsenko
Keywords
Related Articles
- EP ID EP293814
- DOI 10.20998/2074-272X.2017.6.08
- Views 113
- Downloads 0
MODELING OF AN ADVANCED HEAT EXCHANGE UNIT WITH MICROCHANNELS FOR A COMBINED PHOTOENERGY SYSTEM
Purpose. Mathematical modeling of the heat exchange unit main parameters for photoenergy system based on general models with forced circulation of heat transfer fluid. Methodology. To determine the coefficient of heat tr...
STATISTIC METHODS OF POLYIMIDE ENAMEL ISOLATION DEFECTIVE NON-DESTRUCTIVE CONTROL AT THE CONDITIONS OF PRODUCTION
In this paper can be used to not-destructive technological testing of defects isolation enameled wire with polyimide polymer. The thesis is devoted to the statistical method for processing, comparison and analysis of res...
ANALYSIS OF ENERGY EFFICIENCY OF OPERATING MODES OF ELECTRICAL SYSTEMS WITH THE TRACTION LOADS
Innovative scenarios of reliable energy supply of transportation process aimed at reducing the specific energy consumption and increase energy efficiency of the systems of electric traction. The paper suggests innovative...
INVESTIGATION OF CHANGES OF PHYSICAL AND CHEMICAL PROPERTIES OF TAP WATER UNDER INFLUENCE OF POWERFUL UNDERWATER SPARK DISCHARGES
Purpose. The purpose of this investigation is to study the changes in the redox potential and pH-value of the tap water as a function of underwater spark discharges, storage device capacitance and the charging voltage. M...
CHARACTERISTICS OF SPECIALIZED SINGLE-PHASE HIGH VOLTAGE DOUBLER RECTIFIER
Introduction. To obtain a high voltage direct current, voltage multipliers with a number of cascades of three or more are widely used. At the same time, for voltage levels of 100…200 kV there are several advantages of us...