Checking procedures of spool valve overlap and ports opening timing for hydraulic servomechanism SMHR included in the aileron control chain of IAR 99
Journal Title: INCAS BULLETIN - Year 2010, Vol 2, Issue 4
Abstract
This procedure was developed and used to provide laboratory measurements of spool valve overlap and ports opening timing in the framework of hydraulic servomechanism SMHR qualification tests, in the ‘80s.
Authors and Affiliations
Constanta TIVIG
Thrust and jet directional control using the Coanda effect
The application of the Coandă effect to the directional control of a jet or thrust is presented. Deviation of the thrust force by direct flow can be achieved by using the Coandă effect to change the angle of the primary...
Acoustic control study of turbofan nozzles with triangular chevrons
This paper has a small part dealing with the notion of chevron and the process that helps reducing the noise pollution. Based on the gas dynamics and the geometrical parameters of the turbofan jet engine a model of CFD d...
Aerodynamic Analysis of C-Wing Aircraft
In the recent years, the researchers focused on the development of long-range aircraft with the commercial aid of nonconventional design concepts. The C-wing concepts for large aircraft are highly preferred to overcome t...
Low-Order GAM Admire System in Landing Preparation Phase
In this paper the symbolic and numeric computations for the simplified GAM (Generic Aerodynamic Model) Admire system are presented . The numeric computations were performed into the MatLab environment with the aim of pre...
The laminar boundary layer on a rotating wind turbine blade
The present paper describes a method to calculate velocity profiles in the boundary layer of rotating blade. A differential approach is used to solve the laminar boundary layer equations. The effects of tip speed ratio,...