CHOSEN PROPERTIES OF SANDWICH MATERIAL Ti-304 STAINLESS STEEL AFTER EXPLOSIVE WELDING
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2011, Vol 18, Issue 1
Abstract
The work deals with evaluation of joint of stainless steel 304 SS (sheet) and commercially pure Ti both after welding explosion and followed-up annealing at 600°C/1.5h/air. The bonding line shows sinusoidal character with curls in crest unlike the trough of the sine curve. The heat treatment does not change the character of the interface. In work amplitude, wave length and the interface thickness were measured. Thickness of compressed cladded matrix of Ti was measured in area of crests and troughs. In crest of joint melted zones were studied, where complex oxides and intermetallic phases were revealed
Authors and Affiliations
Dmytro Ostroushko, Eva Mazancová
Keywords
Related Articles
- EP ID EP145133
- DOI -
- Views 115
- Downloads 0
MECHANICAL CHARACTERIZATION OF FRICTION WELDED DISSIMILAR STEELS AT 1000 rpm
Joining of dissimilar metals is one of the most essential needs of industries. There are various welding methods that have been developed to obtain suitable joints in various applications. However, friction welding is a...
Deformation zone size around drilled hole in DP steels
In the present study, there are given results of the experimental tests primarily focused on determination of dimension of plastic strained layer near drilled hole surface. Three hot rolled low carbon steels with strengt...
NANOINDENTATION TEST FOR DLC COATING ANALYSIS
In this report the effects of the substrate on the microhardness of Diamond like carbon (DLC) thin films were investigated. The DLC coatings were deposited by Radio Frequency Plasma Actived Chemical Vapor Deposition (RF...
The degradation of lining of rotary furnaces in the production of zinc oxide
This paper is closely connected with the complex problem of degradation relating to the refractories of rotary furnace linings in the production of zinc oxide. Zinc oxide can be produced by variety of ways, but the most...
Static and dynamic tensile characteristics of DP600 steel sheets
Dynamic tensile testing of sheet steels is becoming more important. Experimental dynamic tensile technique is depending on the strain rate. Each serves for a specific range of strain rates and provides specific type of i...