Comparative analysis of the crystal-like and traditional microstrip structures efficiency
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2014, Vol 0, Issue 59
Abstract
Introduction. Microstrip frequency selective devices are widely used in radio systems for various purposes. Crystal-like structures and devices that used for frequency selection of signals problems are described. Crystal-like inhomogeneities. The types of inhomogeneities in microstrip devices are viewed. The limitations of the effectiveness of traditional microstrip structures are analyzed. Electromagnetic crystals efficiency. The efficiency of the EC based on proposed inhomogeneities with traditional solutions based on microstrip line is compared. It is shown that by using three-dimensional inhomogeneities in the EC structure, area is reduced by 40%. Comparison of the devices’ characteristics. On an example of the narrow-band filter efficiency of the proposed three-dimensional low-impedance EC-inhomogeneities from the side of the signal conductor with one-dimensional inhomogeneities of traditional microstrip line are compared. It is shown that the filter width reduced in half. Conclusions. Using the proposed three-dimensional low-and high-impedance EC-inhomogeneities in the structure of EC increases its efficiency in comparison with traditional microstrip line. Thus, value of Tmin decreases from –43 dB to –73 dB for one of the considered ECs. The transition from single- and two-dimensional inhomogeneities to three-dimensional low-impedance inhomogeneities from the side of the signal conductor reduces the width of EC-filter twice.
Authors and Affiliations
A. Nazarko
Divergence elimination of the extended Kalman filter for target tracking due to Pulse-Doppler radar measurements
Extended Kalman filter for target tracking due to Pulse-Doppler radar measurements is often divergent, which is caused by the presence of unaccounted errors which appear in the result of the equation of the range rate...
Comparative characteristics of different strategies stability of analog circuits optimization
Introduction. Methodology of analog circuits designing was developed before on the basis of control theory application and it allows to use important concepts and results of this theory. Problem formulation. A problem of...
Electronic manual a component of modern educational environment
The comparative analysis of printed and electronic books is carried out. The conditions of effective use of electronic textbook are considered.
Reliability of а radioelectronic equipment cells design at external mechanical influences
The influence of pressure in conclusions of microcircuits, microassembly, and in them solder connections, as result of action of external mechanical loadings – vibrations and impacts – on parameters of reliability of a c...
The main characteristics of SiGe HBTs at low temperatures
The current-voltage curves (CVC) of n-p-n SiGe heterojunction bipolar transistors (HBT) are considered within the temperature range from minus -195˚С up to 25˚С, produced on the SGB25V technology of IHP. The experimental...