Comparative Study of Seismic Forces for the Industrial Structure
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2015, Vol 3, Issue 2
Abstract
Steel is one of the most widely used material for building construction in the world .The inherent strength, toughness and high ductility of steel are characteristics that are ideal for seismic design. To utilize these advantages for seismic applications, the design engineer has to be familiar with the relevant steel design provisions and their intent given in codes. This paper work describes the comparative study of seismic forces with zone. For paper work the equivalent static analysis is carried out for steel building. The industrial structures shall be mainly designed and constructed to resist the wind effects in accordance with the requirements and provisions of IS:875 (Part 3):1987. This standard describes the procedure for wind resistant of such structures .The seismic analysis & design of multi-storey steel building is carried out using Software Computer Aided Design i.e., ( STAAD PRO ) .The main parameters consider for comparing wind performance of buildings are bending moment ,shear force ,deflection and axial force. The seismic design of building frame presented in this paper is based on IS:1893:2002, IS:1893:2005 and IS:800:2007 .The building consists of two storey. The selection of arbitrary sections has been done following a standard procedure. In the process of design the section has undergone numerous iterations till all the criteria mentioned in the IS 800 have been satisfied. The designed frame was again analyzed and results were compared in terms of sections used. Relevant calculations have been shown and the figures have been drawn. The software used for analysis and design is STAAD PRO .Both during design and analysis sufficient manual calculations have been made.
Authors and Affiliations
Kavita K. Ghogare,
Keywords
Related Articles
- EP ID EP19630
- DOI -
- Views 296
- Downloads 4
Influence of Drying Method on Total Flavonoid Content of Phalsa (Grewia asiatica) Fruit
This study aimed to assess the effects of thermal drying (tray drying) and non-thermal drying (freeze drying) on the total flavonoid content (TFC) of tall and dwarf cultivars of phalsa (Grewia asiatica) fruit. Before an...
Linking E-Commerce to Social Networks for Product Recommendation
From past many years to now-a-days we are seeing e-commerce and social networking sites have gradually blurred. Normally, while we are seeing products in social networking sites and we have to buy them, and then we have...
Forward and Backward Sweep Algorithm for Distribution Power Flow Analysis and Comparison of Different Load Flow Methods
Power flow analysis is a very important and fundamental tool for the analysis of any electrical distribution system and is used in the operational as well as planning stages. Certain applications particularly in distrib...
Co-Primary Multi-Operator for Optimal Resources and Spectrum Sharing For Small Cell Networks
To deal with the challenge of providing higher data rates within limited spectral resources, the case of multiple operators sharing a common pool of radio resources is considered.Three algorithms are proposed to address...
Identify the Deterioration in Pipe by Using Wheel Operated Robot
Nowadays, Robots are used in many industries for various purposes. Inspection is the one of the field in which robot used as the inspector. One application is monitoring the inside of the pipe, Recognizing and solving p...