Comparative Study on Machinability of Cast Irons with Different Tensile Strength

Journal Title: 河南科技大学学报(自然科学版) - Year 2016, Vol 37, Issue 3

Abstract

A spheroidal graphite cast iron,three compacted graphite irons and a gray cast iron were cast. The main cutting forces of five samples with different tensile strength were measured. The relationships among the tensile strength,main cutting force and microstructure were analyzed. The results show that both of the tensile strength and main cutting force of the cast irons with three graphite morphologies are influenced by the graphite morphology and matrix structure. However,the influence of the graphite morphology on the tensile strength is more obvious and the influence of the pearlite content in matrix on the main cutting force is more obvious. For different kinds of the cast irons,the main cutting force is not well corresponding to the tensile strength.

Authors and Affiliations

Zongliang LI, Fengzhang REN, Bingyang WANG, Yi XIONG

Keywords

Related Articles

Research on Reinforcement Effect of Widening on Existing Bridges

The employment of a new bridge on the widening of the existing bridge had certain reinforcement effect on the existing bridge.With the variation of transverse distribution coefficient before and after the widening of bri...

Microstructure and Properties of Electrodeposited Coatings on Titanium Surface

WC coating and CoCr/WC coating were prepared on the surface of TA2 basis material by electro spark deposition. The morphology, surface roughness, thickness, phase composition, microhardness and relative wear resistance o...

Relevant Parameter Optimization of Lensless Ghost Imaging

In order to improve the image quality of the lensless ghost imaging, a lensless ghost imaging experimental system with second order was constructed based on the pseudo-thermal light.The effect of the correlation number,...

Effect of Preparation Process on Friction and Wear Properties of C/C-SiC Composites

Carbon/carbon porous body of low density reinforced with carbon fiber needled felt were prepared by chemical vapor infiltration (CVI) .Then C/C-SiC composites were prepared by reactive melt infiltration (RMI) and precurs...

Effect of Electronic Thermostat on Fuel Consumption with Fuzzy PID

Aiming at the problem that the traditional internal combustion engine water temperature control system could not accurately, quickly and steadily adjust the engine water temperature, a fuzzy controller was designed in Si...

Download PDF file
  • EP ID EP461041
  • DOI 10.15926/j.cnki.issn1672-6871.2016.03.002
  • Views 73
  • Downloads 0

How To Cite

Zongliang LI, Fengzhang REN, Bingyang WANG, Yi XIONG (2016). Comparative Study on Machinability of Cast Irons with Different Tensile Strength. 河南科技大学学报(自然科学版), 37(3), 6-9. https://europub.co.uk/articles/-A-461041