Comparison of the Interfacial Bond Strength Behaviour using Shear Key
Journal Title: GRD Journal for Engineering - Year 2016, Vol 1, Issue 0
Abstract
Many of the existing reinforced concrete structures throughout the world are in urgent need of strengthening, repair or reconstruction because of deterioration due to various factors like corrosion, lack of detailing, failure of bonding between beam-column joints, increase in service loads, spalling, loss of strength, deflection, etc., Retrofitting techniques have changed the old scenario to construct the new structure always by demolishing the damaged one. Retrofitting is the modification of existing structures to make them more resistant to external force quantities. The objectives like higher loading requirements; damage by accidents and environmental conditions, rectification of initial design flaws, change of usage can be achieved by retrofitting. Though, retrofitting technique have many significant advantages, suffers from a limitation that sometimes can occur which is debonding and BOND SLIP. Thus in this paper, efforts have been made to identify the parameters which plays a major role for causing bond slip and solution have been tried to find out for limiting the same. In this paper efforts have been made to study the bond slip phenomenon in different variety of retrofitted specimen such as jacketed specimen without any bonding agent (Specimen _N) and jacketed specimen with SBR and shear key (Specimen _SK). After performing experiments, the bond strength was evaluated in both of the cases and has given satisfactory results.
Authors and Affiliations
Karan Shah, Rohit Tripathi, Deval Master, Abhay Yadav
Keywords
Related Articles
- EP ID EP296468
- DOI -
- Views 103
- Downloads 0
Solar Powered Auto Irrigation System using GSM Module
Sun powered power is utilized as just the wellspring of energy to control the general framework. Sensors are set on the paddy field and these sensors constantly sense the water substance and give the message to the agric...
Design and Fabrication of In-Pipe Inspection Robot
Many kinds of pipes are being utilized to construct important lifelines such as water and gas supply in our contemporary society. Also pipes are widely used in chemical industries and in gulf countries for carrying petro...
A Low Power Memory Architecture for Zigbee Trans-Receiver
A Low-power memory architecture for Zigbee Trans-Receiver is designed in this project. It proposes a level converting Retention flip-flop (RFF) in dual edge triggered pulse with feedback system in Zigbee SoC’s Trans-rece...
High Speed and Resource Efficient Systolic Architecture for Matrix Multiplication using FPGA
Grid increase is the piece operation utilized as a part of numerous picture and flag handling applications. This work exhibits a viable configuration for the Matrix Multiplication utilizing Systolic Architecture. This de...
Region growth based segmentation to improve the porosity of Cu - (5–20%) W composite preforms
While preparing the composite preform in the powder metallurgy Lab, the various defects due to porosity, open crack and residual stresses are possible. This may lead to poor life and strength of materials. It is difficul...