Computer modelling characteristics of ballast choke of the fluorescent lamp
Journal Title: Вісник Тернопільського національного технічного університету - Year 2015, Vol 77, Issue 1
Abstract
Basing on the analysis of existing structures of the planar system induction coils authors proposed to fill the space between the turns of the coil by the ferromagnetic material. This design will increase the magnetic inductance, and will not increase of the dimension parameters. As the magnetic material nickel-zinc ferrite with specific resistance was chosen. Modeling of magnetic and temperature characteristics was conducted by the Comsol Multiphysics software. It is shown that proposed construction of magnetic makes possible to get get the necessary inductance and quality factor of choke in comparison with traditional designs of magnetic circuit. Based on the investigations, the authors proposed the recommendations concerning the choice of optimal parameters of inductive element, taking into account the index of operating current. It is shown that the small increase of inner orifice radius gives the opportunity to increase inductance with the small change of element’s sizes, while the index of quality factor stays practically unchangeable. Based on the simulation of magnetic and thermic field of choke, it is shown that the layers of insulating material serve as non-magnetic air gap. The elaborated computer model lets choose its thickness for providing the stationary inductance index in the process of remagnetizing. According to the carried out research the operating temperature of the choke doesn’t exceed 70 °C. Such temperature is northing operating temperature range of choke materials, besides it won’t cause the excessive heating of surrounding components in the scheme during operating. The quantity of heat consumptions that in the coil and consumptions in the magnetic circuit is three times less than those with traditional types of magnetic circuit. The simulation (modeling) of work of the discharged stage operating of electronic starting system set in the established mode is held. It is showen that the proposed design of ballast choke provides the necessary indexes of voltage and current during the operating of the luminescent lamp. Due to the reduction of heat consumptions the proposed design increases the efficiency of luminescent lamp power supply system
Authors and Affiliations
Volodimir Andriychuk, Myroslav Nakonechniy
Keywords
Related Articles
- EP ID EP571964
- DOI -
- Views 63
- Downloads 0
Investigation of the shock waves impact on the dynamic stress state of medium with the system of tunnel cavities
The method to study distribution of dynamic stresses in elastic bodies with tunnel cavities according to integrated and discrete Fourier transform over time has been developed in the paper. In the field of Fourier transf...
The flow of concentrated force through open elastic rod to the contour of the curved hole in infinite plate
The new approach to the problem of the flow to the contour of the curved hole in an infinite isotropic plate of concentrated force, applied to the end of reinforcing open elastic bar of constant rectangle cross section,...
Effect of binder with nano Ni on mechanicalproperties of TiC based hard alloys
Titanium carbide based hard alloys with nickel-chromium binder possess high hardness, wear and heat resistance. In order to improve physical and mechanical properties of alloys the polycarbide basis TiC-5WC-5NbC and Ni (...
Experimental and probabilistic numerical modeling of impact of fiber-reinforced composites at high and low velocities
Peculiarities of energy absorption dynamics and the damage of plates of multicomponent composite material are analysed depending on the impact speed at impact velocities ranging from 20 to 1500 m/s in view of causing the...
Technological conditions of diffusive boride coating formation on silicon carbide and molybdenum disilicide
Basic directions of the diffusive boride coating formation on reaction-sintered silicon carbide and molybdenum disilicide are described. Technological conditions of non-metal ceramic materials boriding depending on the c...