CONSTRUCTION OF THE TEST STAND FOR TESTING THE SEAT BACK OF BOAT AND YACHT ARMCHAIRS BASED ON THE ABYC STANDARDS
Journal Title: Journal of Machine Construction and Maintenance - Year 2018, Vol 110, Issue 3
Abstract
Polish standards do not specify the research of yacht and boat armchairs that should be carried out before the introduction of a new armchair construction to the sales market. The only available standard that describes the method of testing boat and yacht armchairs is the “ABYC H-31 – Seat Structures” standard. The tests included in this standard are divided into several types of tests. The tests concern, among others, back and bottom seat tests. The article presents the requirements and methodology of testing the backs of armchairs intended for boats and yachts. The requirements are discussed based on the ABYC-H31 standards. The construction of a test stand for testing armchair backs is also presented. The article also contains exemplary results of the study of the armchair back of one of the prototype solutions of yacht armchair.
Authors and Affiliations
Robert Sołtysiak, Paweł Maćkowiak, Maciej KOTYK, Agnieszka Sołtysiak
Keywords
Related Articles
- EP ID EP614972
- DOI -
- Views 165
- Downloads 0
TUNGSTEN DOPED TiB2 COATINGS OBTAINED BY MAGNETRON SPUTTERING
The aim of the work was to investigate the possibilities of shaping the properties of TiB2 coatings by doping with tungsten, which create hard boron phases (e.g., WB2, WB4, and W2B5). The coatings were produced by a DC m...
THERMOREFINERY: PROSPECTS FOR THE SECOND GENERATION OF THERMO-CHEMICAL BIOMASS CONVERSION SYSTEMS
The ThermoRefinery is a new concept and an associated practice representing the 2nd generation of thermochemical processes for the conversion of renewable feedstocks (biomass and wastes) to fuels, chemicals and other bio...
ANALYSIS OF THE FLOW OF GAS/POWDER MIXTURE IN THE OXYGEN CONVERTER LANCE NOZZLES
A numerical solution of mathematical equations for the carrier gas and powder flow and numerical variables were used for establishing the effect of carrier gas pressure at the nozzles on the change of the thermodynamic f...
ESTIMATION OF SHAPE OF AFM TIP WITH “CROSS-FORREST” CALIBRATION STANDARD
The “Cross-Forrest” tip shape calibration standard for regularized blind tip reconstruction has been fabricated and investigated. The confirmation of previously reported theoretical findings is shown. However, the KSVD-O...
VARIABILITY OF THE DIESEL FUEL SPRAY MICROSTRUCTURE DURING THE INJECTION INTO STAGNANT AIR BY A TYPICAL DIESEL ENGINE INJECTOR
The article presents the results of a study on the distribution of Sauter Mean Diameter (SMD) along the axis of an atomized diesel oil spray and changes in SMD occurring during the injection in selected cross-section of...