Design, modeling and dynamic simulation of three double stage gearboxes with different module, mesh stiffness fluctuation and different level tooth breakage
Journal Title: Revista Facultad de Ingeniería-Universidad de Antioquia - Year 2015, Vol 1, Issue 74
Abstract
This paper presents the detection of failure in gears using, as a statistical indicator, the Root Mean Square value from the vibration residual signal. Models for three double stage gearboxes are considered on the analysis. The gear models are designed with different modules in order to preserve geometrical resemblance. This research shows the variation on gear mesh stiffness for different amounts of damage. This paper also describes the development of a model to simulate the vibration response from the double stage gearbox for conditions with and without failure. The variation on time of the gear mesh stiffness is taken into account on the dynamic simulation, and damping coefficient is considered proportional to gear mesh stiffness. Results obtained from dynamic simulation for both good state and with failure teeth are in accordance with the results reported on literature.
Authors and Affiliations
Jairo Alberto Ruiz-Botero, Juan Fernando López-López, Héctor Fabio Quintero-Riaza
Keywords
Related Articles
- EP ID EP626365
- DOI -
- Views 133
- Downloads 0
Graphene samples preparation and some possible uses in developing optical communication devices
Graphene is a two-dimensional material which has been attracting the attention of worldwide scientific community, motivated by their optical and electronic properties. There are different methods for obtaining grapheme;...
Experimental characterization of thermal hydraulic performance of louvered brazed plate fin heat exchangers
Louvered fins are commonly used in compact heat exchangers to increase the surface area, turbulence, and initiate new boundary layer growth required to improve the heat transfer performance without a significant increase...
Chitosan/hydroxyapatite scaffolds for tissue engineering manufacturing method effect comparison
The regeneration of bone is one of the main challenges of modern medicine because many diseases including trauma and tumor can cause bone defects. Tissue engineering (TE) is a promising approach to cure these bone diseas...
Low complexity demodulator for BFSK waveforms based on polygonal approximation
The present article relates in general to digital demodulation of Binary Frequency Shift Keying (BFSK waveform). New processing methods for demodulating BFSK-signals are proposed here through the use of segmentation curv...
Influence of meteorology and source variation on airborne Pm10 levels in a high relief tropical Andean city
Atmospheric particulate matter (PM10) was evaluated with meteorology, mixing height and source variation over a two year period (January 2010 to December 2012) in the densely populated tropical Andean city of Manizales....