Determination of Multi-Item Inventory Model with Limitations of Warehouse Capacity and Unit Discount in Leading Garment Industry in Indonesia
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 2
Abstract
Inventory is important so that the company's production process runs smoothly and efficiently. To maintain the supply of raw materials, it is necessary to have an appropriate inventory control system so that inventory problems can be minimized. The raw material used is a type of multi-item to produce intimates of apparel is bra. The actual usage data of raw materials during January - December 2017 experienced a stock out of Nylon Tricot, N / S Elastane, FS Fiberfill, Mesh SM135 and Spacer. Management of raw material inventories has constraints that is the limit of warehouse capacity and discount units. This study aims to determine the number of economical orders and the frequency of bookings for a year with constraints on warehouse capacity and discount units. The method used is EOQ probabilistic multi-item Lagrange Multiplier (LM) and dynamic programming method approaching the Wagner-Within algorithm. From the two methods then compared to find the most optimal solution in determining the number of orders that are economical. The Wagner-within method produces a Total Annual Cost (TAC) of Rp. 137,453,491, while Q * was Rp. 187,339,290 and Q * lagrange multiplier of Rp. 135,982,935. The optimal results seen from the TAC of all the minimum raw materials are obtained by the Q * lagrange multiplier method. With this method Q * lagrange multiplier is recommended for planning multi-item raw material control in the company.
Authors and Affiliations
Rafly Isfanur Yassa, Zulfa Fitri Ikatrinasar
Keywords
Related Articles
- EP ID EP580499
- DOI 10.24247/ijmperdapr201915
- Views 116
- Downloads 0
Dynamic Impact Analysis on ATV Upright
Uprights play a vital role carrying the complete wheel assembly with it and attached to vehicle suspension system. The knuckle has to design in order to sustain all the loads acting on the vehicle during the course of dy...
Effect of Staggered Non-Conductive Partition on Heat Transfer in a Variable Shape Cavity
This paper represents the effect of staggered non-conductive partitions on natural convection heat transfer in variable shape cavity (rectangular, trapezoidal and triangular cavities) have been studied. The three partiti...
Experimental Investigation of the Performance of Internal Combustion Engine by Water/Methanol Injection
This project deals with the development and testing of IC engine using methanol with a water injection system. Nowadays there are many types of fuel injection for example throttle body injection, common rail direct injec...
Low Speed Impact Test of Heavy Duty Bumper
Bumpers are basic parts introduced at the front and backsides of a vehicle to secure, the auto body, frill, and travellers amid low speed impacts. A bumper is a shield made of steel, aluminium, elastic, or plastic that i...
Wear Analysis by Taguchi Technique of Al6061 Based Hybrid Composite Reinforced with Sic and Al2o3
In this paper, wear characteristics of hybrid composite of Al6061 was studied. Hybrid composite was reinforced with silicon carbide (SiC) with varying (3%, 6%, 9%) weight % and keeping the alumina (Al2O3) with constant (...