Determination of Optimum Cutting Parameters Affecting the Surface Form Properties in the Ductile Stainless Steels with Gray Relational Analysis Method
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2018, Vol 6, Issue 3
Abstract
In this study, the effects of cutting parameters with different coatings (TiAlN and TiN) on drilling performance were investigated. Drilling operations were carried out on duplex stainless steels by drilling holes 20 mm deep with 5 mm diameter drills using cooling fluid. Three different cutting speeds (15, 20 and 25 m / min) and 3 different cutting feed values (0.05, 0.075 and 0.1 mm / rev) were used in the experiments. The effects of different drills and cutting parameters on surface form properties have been measured. The experiments were carried out according to the L18 orthogonal test design. The obtained deviation from cylindricality and the deviation values were optimized by means of gray relational analysis method and the appropriate cutoff parameter was determined as A2B1C1.
Authors and Affiliations
Ahmet MAVİ
Keywords
Related Articles
- EP ID EP491134
- DOI 10.29109/gujsc. 395667
- Views 83
- Downloads 0
An Investigation of The Effects of Mn Amount on Wear Behaviors of 7075Al Alloy Produced by Powder Metallurgy Method
In this study, microstructure, hardness and wear behaviors of 7075 Al alloy with adding different amount of Mn were investigated produced by powder metallurgy method. In the scope of the study, four different amount of M...
Integrated Circuits Tester Design for Logic Circuit Laboratories
Logic circuit laboratory is one of the important laboratories for Electrical-Electronics Engineering department. The Integrated Circuits (ICs) must work correctly during the experiments. It is difficult and time-consumin...
The Effects of Shot Peening parameters on the subsurface properties of AA7075 T6 aluminum alloy
Shot peening (SP) is an important mechanical surface treatment widely used to improve the fatigue life of mechanical components operating under dynamic loads which have been specifically used in automotive and aerospace...
Artificial Neural Network Based Early Warning System For Aydin Province Towards Air Factors Which Primarily Affect Human Health
Temperature, air quality index and ultraviolet index, which are basic air parameters, affect human health significantly. It is important to inform people about the precautions to be taken for these factors affecting huma...
Next Generation Emergency Call System For Turkey
Next Generation Emergency Notification System after emergency call (eCall) equipped vehicle regulations with the legislation EU-2015/758 will be an obligation in EU in 2018 and eCall units are set up into the vehicles in...