Development of Numerical Model and Comparison with the Analytical Model for Predicting the Wire Effects in Wire Electric Discharge Grinding
Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2018, Vol 68, Issue 1
Abstract
This paper discusses the development of a numerical model and its comparison with the analytical model to predict the wire deflection in WEDG. The movement of wire between upper and lower guides creates vibration during the machining process which can create micro deflection of the wire. The Finite Element Analysis model [FEA] for the wire deflection is analyzed and compared with the analytical model. The deflection of the wire due to the input current may affect the machining of micro parts, which will be used for further research in micro machining and also will help us to choose the parameters such as current, spark gap, wire feed, and the speed of the workpiece during micro machining with WEDG. The FEA results for various forces were compared with the analytical results and found that the developed numerical model results are in good agreement.
Authors and Affiliations
Parthiban Madhavadev, Krishnaraj Vijayan and Senthilkumar Mouleeswaran
Keywords
Related Articles
- EP ID EP43929
- DOI https://doi.org/10.2478/scjme-2018-0007
- Views 166
- Downloads 0
Studies on Improvement of Performance of Compression Ignition Engine Fuelled with Mixture of Honge Biodiesel and Tire Pyrolysis Oil
The biodiesel has lower volatility and is costlier than the fossil diesel. Hence it is necessary to add a low cost fuel which has higher volatility, with the diesel. The tire pyrolysis oil (TPO) produced from waste tire...
Analysis of Bolt Bending in Preloaded Bolted Joints
Classical analysis methods are applied to show how flexural deflections due to shear strain in the flange pack produce bending moments and tensile loads on bolts within preloaded bolted joints. It was found that in joi...
Modeling of Ice-Shedding from ACSR Power Line
In this contribution, the analysis of ice-shedding from Aluminium Conductor Steel Reinforced (ACSR) power lines is presented. The impact of the icing position on the overhead power lines, the resulting jump height, and...
Internal Combustion Engine Powered by Synthesis Gas from Pyrolysed Plastics
The article discusses the application of synthesis gas from pyrolysis of plastics in petrol engine. The appropriate experimental measurements were performed on a combustion engine LGW 702 designated for micro-cogenerat...
Optimization of Process Parameters for FSW of Al-Mg-Mn-Sc-Zr Alloy Using CCD And RSM
Al-Mg-Mn-Sc-Zr alloy plates of 5mm thick were welded successfully using Friction stir welding (FSW). Three-factor five-level central composite design was adopted for experimentation. Response surface methodology (RSM)...