EFFECT OF THE SUBSTRATE HARDNESS AND ELASTICITY ON THE MICRO-IMPACT FATIGUE WEAR OF THE COATING
Journal Title: Tribologia - Year 2014, Vol 257, Issue 5
Abstract
Micro-impact strength tests of tribological coatings were performed in order to obtain knowledge about cracking and decohesion of coatings under cyclically repeated impact loads, depending on the hardness and elasticity of the substrate. The destruction of the coating is caused by the accumulation of the effects over long periods of time, which are measured by the number of impacts at a set load and kinetic energy. TiN coatings with a thickness of 0.5 μm deposited on austenitic and ferritic steel were investigated. The hardness and elastic modulus of both substrates and coating-substrate systems were determined using a Micro-Combi-Tester from CSM Instruments. Micro-impact fatigue tests were carried out on an impact tester designed and built in the Laboratory of Tribology and Surface Engineering AGH University of Science and Technology. It was found that the elasticity and the hardness of the substrate significantly influence the impact fatigue process.
Authors and Affiliations
Wiesław RAKOWSKI, Sławomir ZIMOWSKI, Paweł ADAMCZYK
Keywords
Related Articles
- EP ID EP261377
- DOI -
- Views 48
- Downloads 0
EFFECT OF THE SINTERING TEMPERATURE ON TRIBOLOGICAL WEAR OF 316L AND 316L-HAp OBTAINED WITH THE USE OF SPARK PLASMA SINTERING
The use of 316L stainless steel in osteoarticular system implants is associated with many operational problems. One of the methods that deal with these restrictions may be the development of new materials, including comp...
Możliwości sterowania siłą tarcia za pomocą prądu elektrycznego przepływającego przez strefę tarcia
Niniejsza publikacja przedstawia sposób sterowania siłą tarcia za pomocą prądu elektrycznego przepływającego przez strefę tarcia. Największe zmiany siły tarcia pojawiają się podczas występowania intensywnych zjawisk trib...
LABORATORY STAND FOR TESTS OF SLIDE BEARINGS BASED ON HEAT BALANCE
In the paper design of the laboratory test stand for slide bearings tests based on heat balance is presented. The description of friction torque and temperature measurement systems installed on the stand are given. The s...
THE INFLUENCE OF MODIFIED ADDITIVE ON USING PROPERTIES OF ECOLOGICAL GREASES
In this article, the investigation result on the influence of additive silica and Teflon on lubricating properties of selected lubricated compositions are presented. For modification of greases made on silica-mineral and...
Badania właściwości tribologicznych brązu CuSn12Ni2