Effect of Zircon Silicate Reinforcements on the Microstructure and Properties of as Cast Al-4.5Cu Matrix Particulate Composites Synthesized via Squeeze Cast Route
Journal Title: Tribology in Industry - Year 2010, Vol 32, Issue 2
Abstract
The as-cast microstructure and properties of Al-4.5Cu/ZrSiO4 particulate composite synthesized via squeezed casting route was studied, varying the percentage ZrSiO4 in the range of 5-25wt%. The result obtained revealed that addition of ZrSiO4 reinforcements, increased the hardness value and apparent porosity by 107.65 and 34.23% respectively and decrease impact energy by 43.16 %. As the weight percent of ZrSiO4 increases in the matrix alloy, the yield and ultimate tensile strength increased by 156.52 and 155.81% up to a maximum of 15% ZrSiO4 addition respectively. The distribution of the brittle ZrSiO4 phase in the ductile matrix alloy led to increase strength and hardness values. These results had shown that, additions of ZrSiO4 particles to Al-4.5Cu matrix alloy improved properties.
Authors and Affiliations
E. G. OKAFOR, V. S. AIGBODION
Influence of Nano-Diamond Particles on the Tribological Characteristics of Nickel Chemical Coatings
Friction and wear of 10 types Ni chemical coatings, with and without heat treatment, containing nano-diamond particles of various size – 0;5 nm; 100 nm; 200 nm and 250 nm, are studied in the paper. Procedure and laborato...
The Effect of Interference on the Friction Torque Characteristics of TPU Based Rotary Lip Seals
The effects of radial force (interface) produced by interference on the static contact properties and frictional characteristics of a radial lip seal are investigated by experimentally. For this reason, a test system has...
Evaluation of Tribological Properties and Optimization of Electroless Ni-P-W Coating under Dry Condition using Grey Fuzzy Analysis
Electroless Ni-P-W coating has enhanced tribological properties compared to the conventional binary alloys. Hence, electroless Ni-W-P, which is a ternary alloy, is synthesized on mild steel substrates. The coatings are h...
Multi-Objective Optimization in Electric Discharge Machining of Aluminium Composite
This paper involves the optimization of input process parameters in Electric Discharge Machining of Aluminium hybrid Metal Matrix Composite. Aluminium AlSi10Mg alloy reinforced with 9 %wt. alumina and 3 %wt. graphite par...
Some Tribological Characterization of “EPDM” Rubber
Ethylene Propylene Diene Monomer (EPDM) rubber emerges as a dominant elastomer for major engineering applications. The major properties of EPDM are its outstanding heat, ozone and weather resistance ability. It has a goo...