Effective Electromechanical Coupling for the Partially Electroded Ceramic Resonators of Different Geometries
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2015, Vol 38, Issue 2
Abstract
Effective electromechanical coupling factor (ECF) was studied on bar, disc and ring ceramic resonators partially covered by electrodes. ECFs were calculated theoretically and verified experimentally. Bar resonators (k31-mode) show maximum value of ECF keff = 0.26 at the electrode aspect ratio equal to 0.75 with calculated values fitting the experimental data for all aspect ratios. Calculations for bar resonators with embedded electrodes (k33-mode) show similar behavior like for k31-mode, but at higher ECFs. Maximum value of ECF for such a mode reaches keff = 0.67 for the electrode aspect ratio of 0.75. Partially electroded disc resonators (kpmode) are well described analytically by one-dimensional model only for the electrode aspect ratios up to 0.5. Maximum value keff = 0.58 for disc resonators was measured at the electrode aspect ratio equal to 0.80. Partially electroded ring resonators (kp-mode) show the same trend as discs without saturation of ECF values. Maximum ECF keff = 0.34 was measured for ring resonators with full electrode. The presented analytical formulae may serve as a guide for the optimum electrode pattern design for the partially electroded resonators.
Authors and Affiliations
ERHART JIŘÍ, Sebastian TUTU
Keywords
Related Articles
- EP ID EP581358
- DOI -
- Views 89
- Downloads 0
The Influence of Cold Rolling on the Microstructure for Drawing Steels
The paper presents the structural changes that appeared in steel for deep drawing, as a result of cold rolling and of recrystallization thermal treatment. The research was conducted on samples taken from the rolled strap...
Characterization of the Red Mud Resulted from the Alumina Bayer Process Production for the Future Use in Geopolymers Synthesis
This paper presents the results of analyses on the chemical, structural and morphological processing of bauxite red mud resulting from alkaline wet Bayer technology. The characterization of the material considered as was...
Structure and Corrosive Firmness of Composition Materials on the Basis of Copper and Molybdenum Got Method Electron-Beam Technology
The article describe the study of corrosive firmness of composition materials on the basis of copper, obtained by EB-PVD method. Corrosive firmness of condensates was explored by gravimetric method. The especially decrea...
Industrial Electron-Beam Equipment on Base of Noble and Non-Ferrous Metals
Method of obtaining of metals and alloys by melting – is basic. By this way make in practice the majority of metals, alloys and ligatures. The essence of a method is, that in special melting device (furnace) to melt meta...
Intercritical Thermomechanical Treatments Applied to the Steel Heavy Plates
This paperwork shows the laboratory experiments made on X60 and X65 steels with several intercritical thermomechanical treatment applications. Two variants were used: "down-up" thermomechanical treatment with heating and...