Effects of Ti/Mg molar ratio on bi-supported SiO2/MgCl2 (ethoxide type)/TiCl4 catalysts in ethylene homopolymerization and ethylene/1-hexene copolymerization
Journal Title: Polyolefins Journal - Year 2018, Vol 5, Issue 1
Abstract
SiO2/MgCl2 (ethoxide type)/TiCl4 Ziegler-Natta catalysts for use in ethylene polymerization and ethylene/1-hexene copolymerization have been prepared using silica with a supported layer of magnesium ethoxide (Mg(OEt)2) as a catalyst precursor, followed by treating with TiCl4 at different Ti/Mg molar ratios, which showed significant effects on the active centers and pore structures of the catalysts. The formation amount of β-MgCl2 carrier increased to a maximum with increasing the Ti/Mg molar ratio from 1.50 to 2.25, and then decreased with the further increasing of Ti/Mg molar to 2.50. When the Ti/Mg molar ratio reached 2.25, the catalyst showed the best performance of polymerization, which could be attributed to the most active centers, high surface area and loose surface structure, mainly owing to the high conversion of Mg(OEt)2 to β-MgCl2. The polymers obtained showed medium and high molecular weight (Mw) with medium molecular weight distribution (MWD). In contrast to the conventional Mg(OEt)2-based ZN catalysts, the sphericity of particles was easy to control in this bi-supported catalyst. Furthermore, the prepared catalysts exhibited rather high activity, good copolymerization ability and hydrogen response.
Authors and Affiliations
Liang Zhu, Xuelian He, Ruihua Cheng, Ning ZHAO, Boping Liu
Keywords
Related Articles
- EP ID EP283205
- DOI 10.22063/POJ.2017.1470
- Views 105
- Downloads 0
Discovery and development of metallocene-based polyolefins with special properties
Beside Ziegler-Natta and Phillips catalysts the development of methylaluminoxane (MAO) as cocatalyst in combination with metallocenes or other transition metal complexes for the polymerization of olefins has widely incre...
Introduction of titanium species into fluorine-modified SiO2- supported Cr-V bimetallic catalyst for ethylene polymerization and ethylene/1-hexene copolymerization
Chromium-vanadium (Cr-V) bimetallic catalysts are prepared by the introduction of vanadium into the Phillips catalyst which is one of the most significant industrial ethylene polymerization catalysts for tuning the Phill...
Thermal-insulation performance of low density polyethylene (LDPE) foams: Comparison between two radiation thermal conductivity models
The loss of energy, especially in industrial and residential buildings is one of the main reasons of increased energy consumption. Improving the thermal insulation properties of materials is a fundamental method for redu...
The effect of high-energy electron beam on drawn and undrawn high density polyethylene fibers
HDPE monofilaments were obtained using different extruders and drawn by post-extruder equipments. After solidification, drawn and undrawn monofilaments (draw ratio 7:1) were irradiated with 10 MeV electron beams in air a...
Effect of temperature, heating rate and zeolite-based catalysts on the pyrolysis of high impact polystyrene (HIPS) waste to produce fuel-like products
Pyrolysis of high impact polystyrene (HIPS) waste has been investigated under different process parameters, such as temperature, heating rate and types of zeolitic catalysts to produce valuable liquid products. Liquid, g...