Experimental of Forced Vibration System of Single Degree of Freedom on Tray Type Dryer
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 1
Abstract
This study aims to determine the speed of the briquette dryer used on the drying rack. The method used in this study is a payment system that is used to determine the system used to measure resonance, reliable and reverse the available briquettes in the shelf for later use in the drying process, and can be accessed from the rate of the flow of cement from charcoal briquettes. Charcoal briquettes are generally dried by drying in the sun or by using a dryer. The process of removing charcoal briquettes will result in poor shedding as a result of the charcoal briquettes sundries with other charcoal briquettes or with their shelves, dry air notes cannot touch the entire surface. Therefore, briquettes are needed to be reversed during the stacking process, so that the entire surface touches the air temperature evenly. To facilitate and speed up the briquette process, a system that can be used to reverse and reverse briquettes without the need to reverse them manually is added to the tool shelves. After testing the vibration system in this rack system, the system used to measure the load between 10 - 20 kg, eccentric mass (m) weighing 0.9 kg with eccentricity (e) 0, 0535 m, and motor rotation (n) at level 2 speed.
Authors and Affiliations
LA Ode Mohammad Firman, Sorimuda Harahap, I Gede Eka Lesmana, Daud Heru
Friction Surfacing of Stainless Steel on Low Carbon Steel for Corrosion Resistance Application-An Experimental Approach
The friction surfacing is one of the friction welding processes, used for deposition of desired material on substrate. These deposits being of solid phase bonding, no external heat source is required and it is very much...
Simultaneous Testing of a Parabolic Dish Concentrated PCM and Non-PCM Solar Receiver
A simultaneous test method is proposed, for evaluating the effect of phase change material (PCM) in the concentrated solar receiver, under similar operating conditions. A 16 m2 parabolic dish concentrator is employed, to...
A Small-Scale Fabrication Facility for Extraction of Alternative Diesel Fuel from Waste Plastic
Plastic waste is viewed as conceivably economy wellspring of chemicals and vitality. Because of the expanding level of private utilization of these plastic materials, colossal measures of squanders are released to the ea...
A REVIEW ON MECHANICAL PROPERTIES OF INTRA-LAYER PALM FIBER (PALMYRA SPOUT) – FLAX – S-GLASS FIBER REINFORCED COMPOSITE
Normally natural fibers are extracted from natural sources like plants and animals. The composite materials made by natural fibers plays the wide range of applications in engineering fields because of eco-friendly and lo...
Design and Analysis of Vehicle Front Axle
A hub is a focal shaft for a turning wheel. On wheeled vehicles, the centre might be settled to the wheels, pivoting with them, or resolved to its environment, with the wheels turning around the hub. The axles serve to t...