FLOW OF A SEMI-BOUNDED STREAM WITH FRICTION AND HEAT EXCHANGE IN THE NOZZLE CHANNEL OF A LIQUID ROCKET ENGINE
Journal Title: Проблеми тертя та зношування - Year 2017, Vol 75, Issue
Abstract
The ways of problem solving of determining frictional losses during cooling of a jet nozzle of a liquid rocket engine by gas-generating gas, taking into account the compressibility, non-isothermicity and gradient of the main flow at blowing of the cooling gas-generating gas along the tangent to the cooled surface are analyzed in article. The momentum coefficient and optimal parameters of the blowing system are calculated using a semi-empirical integral method. Equations for determining the maximum stress are obtained. They depend only on the parameters of the profile of the averaged velocity. Equations can be used to calculate the difference of tangential frictional stresses at the boundaries of each calculated region. The use of integral and numerical methods can be recommended for solving problems of friction and heat-capacity during cooling of the nozzle by a gas-generating gas which is blown along the tangent to the cooled surface of the nozzle.
Authors and Affiliations
YU. M. TERESHCHENKO, K. V. DOROSHENKO, YU. YU. TERESHCHENKO, P. HAMZEG
Keywords
Related Articles
- EP ID EP324530
- DOI -
- Views 58
- Downloads 0
APPLICATION OF CAST OPEN-CELL POROUS ALUMINUM FOR SELF-LUBRICATING BEARINGS
Applicability of cast open-cell porous Al for the use as porous 'self-lubricating bear- ings' was studied experimentally using tribological tests. Samples of open-cell porous Al have been produced by casting the melt of...
FLOW OF A SEMI-BOUNDED STREAM WITH FRICTION AND HEAT EXCHANGE IN THE NOZZLE CHANNEL OF A LIQUID ROCKET ENGINE
The ways of problem solving of determining frictional losses during cooling of a jet nozzle of a liquid rocket engine by gas-generating gas, taking into account the compressibility, non-isothermicity and gradient of the...
THE POSSIBILITY OF THE INTENSIFICATION OF THE HEAT TRANSFER IN FRICTION UNITS OF BAND-BLOCK BRAKES OF THE DRAW-WORKS
The limiting the heating elements of friction units of the band-block brakes of the draw-works is one of the most significant tasks of the parametric synthesis and design of friction pairs. The intensification of the hea...
THE ESTIMATE OF AMPLITUDE OF RESONANCE OSCILLATIONS OF TOOTH GEAR WITH ASYMMETRIC FUNCTION OF TRANSMISSION RATIO FROM THE ROTOR VIBRATION
The estimate of amplitude of resonance oscillations from the rotor vibration of tooth gear with asymmetric function of transmission ratio is submitted, the analytic dependences for valuation of amplitude of critical osci...
RESTORATION AND ENHANCEMENT OF EMPLOYMENT BODIES OF THE EMERGENCY-TAKING INSTRUMENT
To accomplish the task of saving people and material values, the rescuers of the DSNU use a variety of equipment and special tools, the reliability of which depends not only on the lives of victims, but also on the rescu...