FRICTIONAL RESISTANCE OF POLYMER MATERIALS DURING SLIDING ON ICE
Journal Title: Tribologia - Year 2011, Vol 239, Issue 5
Abstract
Specific properties of the water in the solid state (ice) allow sliding other solids on ice with low friction. There are some different phenomena that affect the friction during sliding polymer materials on ice. The authors present the results of the influence of ambient temperature (from -30 to -5°C) on the friction coefficient (static and kinetic) of selected plastics (thermoplastics: PTFE, POM PE-HD and elastomers: NBR, PUR, SI) during sliding on ice. Tribological investigations were carried out on the rig “pin-on-disk” which was placed in a climatic chamber. It enabled us to control the environment conditions. The results showed that the frictional coefficients of investigated materials decreases with temperature increase. The exceptions were the elastomeric materials (NBR, PUR), for which the reduction in the frictional coefficient was observed at temperatures below -20°C. The reason was the change in the elasticity (stiffness) of these materials together with the temperature decrease.
Authors and Affiliations
Wojciech Wieleba, Anna Dobrowolska
INFLUENCE OF FILLERS ON THE RHEOLOGICAL PROPERTIES OF THEIR COMPOSITIONS WITH LUBRICATING GREASES
The paper presents the results of studies on the influence of fillers, introduced into lubricating greases, on the rheological properties of resultant grease compositions. These fillers were graphite and PTFE powders. Th...
THE INFLUENCE OF ADDITIVES ON THE OXIDATIVE STABILITY AND FATIGUE LIFE OF LUBRICATED FRICTION PAIRS
The objective of the study was to determine the influence of different additives, namely, graphite, nanostructures of carbon, and polymer PTFE on the lubricating properties in reference to grease based on paraffin oil wi...
WŁAŚCIWOŚCI TRIBOLOGICZNE STALI ŁOŻYSKOWEJ PO OBRÓBCE HYBRYDOWEJ, ŁĄCZĄCEJ DYFUZYJNE CHROMOWANIE Z METODĄ PVD
Przedmiot badań w niniejszej pracy stanowiła modyfikacja budowy warstw chromowanych na stali łożyskowej przez połączenie chromowania dyfuzyjnego z następną obróbką, osadzaniem azotku chromu metodą PVD, przeprowadzana dla...
EFFECT OF THE SINTERING TEMPERATURE ON TRIBOLOGICAL WEAR OF 316L AND 316L-HAp OBTAINED WITH THE USE OF SPARK PLASMA SINTERING
The use of 316L stainless steel in osteoarticular system implants is associated with many operational problems. One of the methods that deal with these restrictions may be the development of new materials, including comp...
THE INFLUENCE OF THE KIND OF COMPOSITE FRICTION MATERIAL ON MORPHOLOGY AND COMPOSITION OF ITS SURFACE LAYER AND TRIBOLOGICAL PROPERTIES
Praca przedstawia charakterystykę materiałów stosowanych aktualnie w budowie okładzin hamulcowych samochodów osobowych, zwracając uwagę na ich wady i zalety. Na tym tle, kierując się oczekiwaniami ze strony klientów oraz...