Fuzzy Logic-Based Pole Type Selection for Transmission Lines
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2014, Vol 2, Issue 4
Abstract
Demand for electricity is increasing as a result of increasing the number of electrical devices with the developing industry and population growth. With the increasing demand for energy, the generation and transmission of the energy required is in a steady increase. Requested that higher powers, where the production of electricity to the consumption centers, generally transmitted by overhead line with high and medium-voltage values. The installation costs of power transmission lines to be established are very high. One of the important factors affecting the cost is the pole length, type and number. After the installation area of the transmission line is specified, optimum type and number of towers is determined. Thus a solution is attempted to provide minimum cost and maximum safety. In this study, fuzzy logic method is used for determining the number of poles which an important factor in the calculations. It can be seen a good agreement between the results obtained by fuzzy-based calculation and made by hand.
Authors and Affiliations
Mehmet Rıda TÜR, Zafer AYDOĞMUŞ
Keywords
Related Articles
- EP ID EP470043
- DOI -
- Views 130
- Downloads 0
Determination of Optimum Cutting Parameters Affecting the Surface Form Properties in the Ductile Stainless Steels with Gray Relational Analysis Method
In this study, the effects of cutting parameters with different coatings (TiAlN and TiN) on drilling performance were investigated. Drilling operations were carried out on duplex stainless steels by drilling holes 20 mm...
Control And Monitoring Of Controller Area Network Based Motor And Sensor Boards
Remote control system also can use to provide the control of devices that are used in industrial environments nowadays. In this study, three experimental modules and one master module have been developed by using Arduino...
Effect of Insulation Thickness on Thermal Stratification in Hot Water Tanks Abstract
One of the important factors to be considered in increasing the efficiency of hot water storage tanks used for thermal energy storage is thermal stratification. Reducing the temperature of the water at the base of the ta...
The Design of Extended Complex Kalman Filter Based Speed-Sensorless Induction Motor Drive
In this study, an extended complex Kalman filter (ECKF) based induction motor drive is performed which fulfills the estimations of the stator stationary axis components of stator currents, stator stationary axis componen...
The Experimental Investigation of Springback in Titanium Grade 1 Sheet Material and Prediction by Fuzzy Logic
In this study, the springback phenomenon of Titanium Grade 1 sheet metal which is observed after V bending operations in room temperature was investigated experimentally. Bending angle, punch radius and holding time are...