GEOMETRIC STRUCTURE OF THE GEAR TEETH SIDE SURFACES AND THE PROCESS OF FATIGUE WEAR
Journal Title: Tribologia - Year 2009, Vol 227, Issue 5
Abstract
This study investigates the geometric parameters of the gear teeth side surfaces, formed in the final stage of manufacturing and processing and their influence on the fatigue wear of the surface. Tests were run on gear teeth whose geometry is shaped through the application of two types of finishing treatment: grinding (procedure A) and gear shaving (procedure B). Geometry of the teeth surface is examined on the basis of selected volume and surface parameters as well as functional features. Experimental tests on fatigue wear of the tooth side surface became the starting points for assigning the values of parameters characterising the geometric structure of the examined surface in relation to the determined level of fatigue wear in contact.<br/><br/>
Authors and Affiliations
Jan Zwolak
Keywords
Related Articles
- EP ID EP517106
- DOI -
- Views 61
- Downloads 0
THE EFFECT OF ABRASIVE MASS MOISTURE CONTENT ON THE ABRASION-RESISTANT STEEL WEAR RATE
This paper presents the results of tests for Hardox Extreme Steel wear rate in an abrasive mass of varying moisture contents. The tests were conducted by the “rotating bowl” method using quartz sand with a grain size of...
Ocena parametrów chropowatości powierzchni toczonych otworów w kołach zębatych obrabianych nagniataniem
W artykule zaprezentowano wyniki z badań eksperymentalnych dotyczących przygotowania powierzchni do obróbki wykończeniowej nagniataniem. Badania dotyczyły obróbki materiałów w stanie utwardzonym po hartowaniu. Analizowan...
ANALYSIS OF THE WAVE DEFORMATION OF THIN COATINGS IN SLIDING POINT CONTACT
This paper presents an analysis of the wave deformation nature of the friction track in a sliding point contact. The object of this study was a composite nickel-molybdenum coating reinforced by the particles of aluminium...
SIDE PRESSURE IN THE CLOSED FORM DURING THE COMPACTION PROCESS OF LIME-SAND MIXTURE
The article presents an analysis of the impact of compacted granular materials, for example, lime-sand mixture (used in the manufacture of lime-sand brick), the side walls in a closed form. Based on experimental studies,...
BADANIA ZUŻYCIA SŁUPKÓW W KORONKACH WIERTNICZYCH DO WIERCENIA OTWORÓW STRZAŁOWYCH
W artykule przedstawiono rezultaty badań zużycia słupków w wybranych typach koronek wiertniczych o średnicy 95 mm stosowanych do wierceń otworów strzałowych w górnictwie skalnym. Celem badań było ustalenie rodzaju zużyci...