Influence of Cooling Oil on the Surface Quality of the Rolled Strip
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2014, Vol 37, Issue 4
Abstract
The excess of emulsion used in the lamination process leads to the formation of drops which in the annealing process forms spots of burned emulsion. It was also shown to cause formation areas with high carbon concentrations on the surface of the steel strips, after annealing. In the cold rolling process, the surface of the rolled strip is contaminated by cooling oil or emulsion and other chemical compounds, which could considerably influence the final quality of the strip. The microscopic analysis of the spots of burned emulsion showed a complex phase structure resulting from the combustion rate through the interaction between the emulsion and the contaminating residues, as well as the one between the emulsion and the steel substrate.
Authors and Affiliations
Tamara RADU, Stela CONSTANTINESCU, Florentina POTECAȘU
Keywords
Related Articles
- EP ID EP583145
- DOI -
- Views 88
- Downloads 0
A Design of New Brands of Martenzite Steels by Artificial Neural Networks
The paper proposes a model-based approach for the design of martenzite structure steels with improved mechanical and plastic characteristics using proper composition and thermal treatment. For that purpose, artificial ne...
Phosphate Passivation Solutions Enhanced by Chemical Additives for Treatment of the Hot Dip Galvanized Steel
To stabilize the surface of the galvanized steel it is important to apply a passivation treatment during its manufacturing. The general aim of the passivation treatment is to prevent the formation “storage stain” or “whi...
The Eco-Efficiency of Recycling Organic Waste for Agriculture Purposes
One of the problems of the cities is the raising of household waste, with polluting effects on the environment. On the other hand, in agriculture, through specific activities necessary to ensure food, fertilizers are nee...
Improvement of Photovoltaic Cells Efficiency by Reducing Contamination in Single Chamber PECVD System by Passivation with a-Si:H and μc-Si:H Thin Films
High performance solar cells, deposited in a single chamber, can be obtained when low levels of contamination exists for the p-,i-,n- layers. This is a recurrent problem not only in the laboratories, but also in the indu...
Prediction of Buckling and Postbuckling Behaviour of Composite Ship Panels
The behavior of ship plating normally depends on a variety of influential factors, namely geometric/material properties, loading characteristics, initial imperfections, boundary conditions and deterioration arising from...