Influence of permeability anisotropy on heat transfer and permeability evolution in geothermal reservoir
Journal Title: Advances in Geo-Energy Research - Year 2019, Vol 3, Issue 1
Abstract
Extracting heat energy from geothermal reservoirs essentially relies on circulating cold fluid within fractured hot rocks. The intrinsic anisotropic permeability in the reservoir directly affects the path of flow and the associated thermal drawdown from cooling procedure. Consequently, each individual component including thermal, hydraulic, and mechanical field needs to be considered, to evaluate the influence of permeability anisotropy on the thermal production and evolution of rock properties. In this work, the fully implicit coupled simulator TFReact was successfully implemented to generate results prototypical of an enhanced geothermal system. Anisotropic permeability values were generated from the variation of fracture spacing at three orthogonal principal directions, with identical initial fracture aperture. Five case scenarios of permeability anisotropy were simulated to evaluate the influence of anisotropic thermal drawdown in triggering permeability evolution. Analysis of the propagation of the thermal front from injector to producer indicated that low anisotropic permeability values will lead to late cold water breakthrough at producer, slower migration rate and wider sweep area than high anisotropic permeability values. Isotropic permeability scenario showed a lower thermal gradient profile, comparing against the scenarios of anisotropic permeability. The anisotropic value of 0.01 produced the highest power output, while isotropic permeability generated the least power output. Induced thermal stress resulted an unloading response by reducing compressive normal stress in sub-horizontal direction, and thereby increase fracture aperture in sub-horizontal direction. Invariably, the induced thermal expansion stress increased the compressive stress and reduced fracture aperture and permeability. After the same timing of injection-production cycle, the highest anisotropic permeability scenario resulted a factor of 2.5 increment in evolving fracture permeability, while lowest anisotropic permeability scenario lead to a factor of 0.35 decrease in changing fracture permeability. The generated thermal output suggested the most favorable strategy in maximizing thermal sweep across the reservoir, by prompting thermal transfer normal to direction of injector-producer.
Authors and Affiliations
Janim Joshua Ijeje, Quan Gan, Jianchao Cai
Keywords
Related Articles
- EP ID EP414163
- DOI 10.26804/ager.2019.01.03
- Views 102
- Downloads 0
Controlling factors and physical property cutoffs of the tight reservoir in the Liuhe Basin
Tight gas sandstone reservoirs of the Lower Cretaceous Xiahuapidianzi Formation are the main exploration target in the Liuhe Basin in China. Petrology characteristics, reservoir space (pore space), controlling factors an...
An equivalent single-phase flow for oil-water two-phase flow and its potential application in well test
In this work an equivalent single-phase flow model is proposed based on the oil-water two-phase flow equation with saturation-dependent parameters such as equivalent viscosity and equivalent formation volume factor. The...
Rheological and filtration characteristics of drilling fluids enhanced by nanoparticles with selected additives: an experimental study
The suspension properties of drilling fluids containing pure and polymer-treated (partially-hydrolyzed polyacrylamide (PHPA) or Xanthan gum) clay nanoparticles are compared withthose of a conventional water-and-bentonite...
Coalbed methane recovery from multilateral horizontal wells in Southern Qinshui Basin
Since 2006, more than 80 multilateral horizontal wells have been drilled in Panzhuang block, Southern Qinshui Basin. In this paper, 6 typical wells in a region are selected as an example. The thickness of coal, gas conte...
A critical review on fundamental mechanisms of spontaneous imbibition and the impact of boundary condition, fluid viscosity and wettability
Spontaneous imbibition (SI) is one of the primary mechanisms of oil production from matrix system in fractured reservoirs. The main driving force for SI is capillary pressure. Researches relating to SI are moving fast. I...