Intercritical Thermomechanical Treatments of the Microalloyed Steel Products for Welded Structures
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2009, Vol 32, Issue 2
Abstract
This paper shows the laboratory experiments made on several grade steels by applying some intercritical thermomechanical treatments; Two variants were used: “down-up” thermomechanical treatment with heating and rolling in the intercritical range and “up-down” thermomechanical treatment with preliminary complete austenitizing and rolling in the intercritic interval. Structural changes, as well as changes of properties revealed in the experimental variants of the intrercritical treatment, have been compared to those revealed by controlled rolling and normalization states of delivery that are recommended to flat products from these steel grades. High values of the strength characteristics and a good plasticity have been obtained. The paper presents only a part of the results obtained when applying different regimes of thermal and thermomechanical treatment within experimental researches made at laboratory and industrial scale, on thick plates of different thicknesses and qualities of the weldable steels.
Authors and Affiliations
Elisabeta VASILESCU, Ana DONIGA, Marian NEACSU
Keywords
Related Articles
- EP ID EP655773
- DOI -
- Views 50
- Downloads 0
Hydrogen Production by Steam Reforming of Renewable Raw Materials
The paper is based on study of steam reforming of renewable raw materials (bioethanol, biomethane) in stainless steel fixed bed reactor. The β-alumina catalysts with nickel has been synthesized and tested supported. The...
Study of Heat Treatment Influence on Aluminum - Based Alloy ATN-Si10Cu4
This work presents the experimental results concerning the behavior on heat treatment of on aluminum based alloy. The laboratory level experiments achieved on samples of ATN-Si10Cu4 (4145 series) alloy illustrate the va...
Composite Based on AlMg Alloys Obtained by Gas Insufflation
Composite materials are the most advanced class of materials invented and produced by humans in modern times as well as a challenge for the future in the field of scientific and technological performance. They are made u...
Semi-Planetary Rolling and Changes of Fine Structure and Microstructure
The strain intensity in the proximity of planetary cylinder, in the case of semi-planetary rolling is greater than in the proximity of the massive cylinder. This fact leads at the variation of the microstructure and fine...
Characterization of Thick Hard Layers with Ni-Cr-B-Fe-Al Alloy Obtained by Laser Cladding
To increase the resistance to wear and corrosion of the surface layers made from steel with 0.45% C, multilayer deposition was tested by injection of powder with chemical composition of 8.9% Cr, 4.5% Fe, 5.1% B, 2, 4% Al...