Measuring Capacitor Parameters Using Vector Network Analyzers
Journal Title: Elektronika - Year 2014, Vol 18, Issue 1
Abstract
Vector network analyzer (VNA) is versatile measuring equipment which is primarily used for two-port device S parameters measurements. This paper addresses measurement of capacitor parameters using VNA in broad frequency range. The main attention is focused on the measurement accuracy of capacitors parameters using VNA and proper de-embedding of an experimental setup parasitics to get accurate results. Comparative measurement error analysis for different measurement techniques is presented. Suitability of each measurement technique for measurements of capacitor parameters using VNA is discussed and effect of the experimental setup parasitics on the measurement results is addressed. Moreover useful procedures for proper capacitor impedance measurement using VNA are developed.
Authors and Affiliations
Deniss Stepins,, Gundars Asmanis, Aivis Asmanis
Modeling Method of Finite Element Modeler and Electromagnetic Solvers for Education and Research in RF MEMS
Field of electronics engineering is the most captivating among students, researchers and academicians nowadays. With the passage of time the requirement of advance tools for engineering is increasing. Many institutions a...
An improved implementation of hierarchy array multiplier using CslA adder and full swing GDI logic
In this paper, an efficient implementation of a 16 bit array hierarchy multiplier using full swing Gate Diffusion Input (GDI) logic is discussed. Hierarchy multiplier is attractive because of its ability to carry the mul...
Nonparabolic effects in multiple quantum well structures and influence of external magnetic field on dipole matrix elements
We present a method of modeling of nonparabolic effects (NPE) in quantum nanostructures by using second order perturbation theory. We apply this model on multiple quantum well structures and consider the influence of ext...
An Enhanced Incremental Conductance Algorithm for Photovoltaic System
The energy obtained from the photovoltaic array is dependent on the available solar insolation, the panel tilt angle and the power point tracking algorithm of the system. Some of the Conventional MPPT methods are develop...
A Novel Purely Active Electronically Controllable Configuration for Simulating Resistance in Floating Form
This paper proposes a new purely active floating resistance simulation circuit employing two voltage differencing trans-conductance amplifiers (VDTAs). The proposed configuration enjoys following advantageous features; (...