MICROSTRUCTURE AND FRACTOGRAPHIC ANALYSIS OF DAMAGE REASONS OF COGWHEEL
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2012, Vol 19, Issue 2
Abstract
The article provides an analysis of the damaged cogwheel, which was used as the drive wheel (pinion) in the steering gear box of the construction machine. The degradation of the cogwheel arose during the warranty period, after seven months of using of the construction machine. The experimental analysis revealed that the cause of the degradation of the cogwheel was due to high mechanical stress in the operating conditions of construction machine.
Authors and Affiliations
Karin Kocúrová, Marián Hazlinger, Mária Štefániková
Keywords
Related Articles
- EP ID EP114185
- DOI -
- Views 101
- Downloads 0
Study of the influence of agricultural waste on the porosity of clay brick
This paper deals with the influence of two organic residues on the porosity of clay bricks. The insulation capacity of the brick increases with increasing the porosity. Combustible organic additions are often used to for...
MICROSTRUCTURAL STABILITY OF Ti-46Al-8Ta DURING CREEP
The effect of long-term creep exposure on the microstructure stability of a new cast air-hardenable intermetallic alloy with nominal chemical composition Ti-46Al-8Ta (at .%) was studied. Constat load creep test were per...
DEGRADATION OF 0.5Cr-0.5Mo-0.25V STEEL MICROSTRUCTURE DURING EXPLOITATION
Degradation of 0.5Mo-0.5Cr-0.25V material after long-term high-temperature service has been studied by means of microstructure and mechanical properties analysis. Samples were taken from the pipeline with steam leaking...
34CrMo4 steel resistance against the SSC after controlled cooling process
The sulphide stress cracking corrosion resistance of 34CrMo4 steel after the accelerated cooling process under the Ar3 temperature was investigated. Two modes of heat treatment were applied to achieve homogeneous microst...
CHANGES OF RHEOLOGICAL PARAMETERS OF POLYPROPYLENE AND POLYETHYLENE AFTER EXPOSURE IN ALIPHATIC n-HEXANE
Rheological properties of thermoplastic polymer materials before and after exposure to a chemical solution were evaluated using the frequency sweep test, which monitors changes in viscoelastic properties of polymers with...