34CrMo4 steel resistance against the SSC after controlled cooling process
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2014, Vol 21, Issue 2
Abstract
The sulphide stress cracking corrosion resistance of 34CrMo4 steel after the accelerated cooling process under the Ar3 temperature was investigated. Two modes of heat treatment were applied to achieve homogeneous microstructure and at least partially eliminated segregation banding. First mode was based on the cooling up to the 420 °C on the air and subsequent cooling in the quenching bath. Second mode was similar except the temperature of cooling on the air, which was set up to the 460 °C. Afterward in both cases, the stress relief annealing was applied. Both modes of heat treatment resulted in the significantly banded microstructure based on the pearlite, ferrite and modified lower portion of accicular ferrite. The differences in mechanical properties of both cases of heat treatment were minimal. The SSC loading times to failure of both sets did not lead to important differences.
Authors and Affiliations
Pavel Kucera, Eva Mazancova
Keywords
Related Articles
- EP ID EP148089
- DOI -
- Views 127
- Downloads 0
TRIBOLOGICAL PROPERTIES OF CrAgN THIN FILMS
CrN and CrAgN thin films were magnetron sputtered onto the substrate made from Vanadis 6 cold work tool steel. The films were examined on tribological properties using a high temperature Pin-on-disc tribometer. Obtained...
SOLUTION TREATMENT EFFECT ON MICROSTRUCTURE AND MECHANICAL PROPERTIES OF AUTOMOTIVE CAST ALLOY
The contribution describes influence of the heat treatment (solution treatment at temperature 545°C and 565°C with different holding time 2, 4, 8, 16 and 32 hours; than water quenching at 40°C and natural aging at room t...
MICROSTRUCTURAL STABILITY OF Ti-46Al-8Ta DURING CREEP
The effect of long-term creep exposure on the microstructure stability of a new cast air-hardenable intermetallic alloy with nominal chemical composition Ti-46Al-8Ta (at .%) was studied. Constat load creep test were per...
The investigation of the corrosion resistance of the tension clamps Skl14
At the level crossings it is possible to find the problems with the corrosion of the parts of the fastening system. These problems are especially at the rubber level crossings and in the tunnels. As a part of the thesis...