MICROSTRUCTURE EVOLUTION OF PURE TITANIUM DURING ECAP
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2011, Vol 18, Issue 3
Abstract
The main goal of the presented paper was to describe deformation behaviour of the commercial purity titanium during the ECAP method. Attention was paid particularly on reached mechanical properties of above mentioned material. Design of experiments rested in extrusion at temperature in range from room temperature up to 280°C. The way of approach was planned in investigation of imposed strain accumulation ability. Among used methods for determination of intended aims were tensile tests, TEM, SEM. Mechanical properties were evaluated using standard tensile tests as well as small punch tests. Correlation between mechanical properties from tensile test and punch test was developed. Depending on imposed strain (e = 2 up to 8) was found that mechanical properties (namely tensile strength) have increased up to 960 MPa. Developed ECAP process enables controlling morphology of microstructural constituents and workability of titanium Grade 1.
Authors and Affiliations
Miroslav Greger, Ladislav Kander, Václav Snášel, Martin Černý
Keywords
Related Articles
- EP ID EP150386
- DOI -
- Views 82
- Downloads 0
Interaction of sub-zero treated Cr-V ledeburitic steel with alumina,100 Cr6 steel and bronze in dry sliding
The interaction of the Vanadis 6 steel, processed without/with an application of sub-zero treatment, with alumina (hard counterface), 100Cr6-ball bearing steel (counterface of an intermediate hardness) and CuSn6 (soft co...
STUDY OF CALCIUM PHOSPHATE (DCPD) ELECTRODEPOSITION PROCESS ON THE Mg-3Al-1Zn MAGNESIUM ALLOY SURFACE
Evaluation of calcium phosphating process realized on the Mg-3Al-1Zn alloy surface after grinding was investigated by electrochemical tests supported by photodocumentation. The electrodeposition treatment was performed b...
The degradation of lining of rotary furnaces in the production of zinc oxide
This paper is closely connected with the complex problem of degradation relating to the refractories of rotary furnace linings in the production of zinc oxide. Zinc oxide can be produced by variety of ways, but the most...
DEGRADATION OF 0.5Cr-0.5Mo-0.25V STEEL MICROSTRUCTURE DURING EXPLOITATION
Degradation of 0.5Mo-0.5Cr-0.25V material after long-term high-temperature service has been studied by means of microstructure and mechanical properties analysis. Samples were taken from the pipeline with steam leaking...
Cyclic plastic behavior and fatigue life of AZ91 alloy in as-cast and ultrafine-grained state
Fatigue properties of magnesium alloy AZ91 in as-cast and in ultrafine-grained state prepared by equal channel angular pressing were investigated. The fatigue strength in the low-cycle fatigue region was found to be subs...