UTILIZATION OF STEREOLOGY FOR QUANTITATIVE ANALYSIS OF PLASTIC DEFORMATION OF FORMING PIECES
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2012, Vol 19, Issue 1
Abstract
Mechanical working leads to final properties of forming pieces, which are affected by conditions of production technology. Utilization of stereology leads to the detail analysis of three-dimensional plastic deformed material structure by different forming technologies, e.g. forging, extruding, upsetting, metal spinning, drawing etc. The microstructure of cold drawing wires was analyzed. Grain boundaries orientation was measured on the parallel section of wire with a different degree of deformation and direct axis plastic deformation was evaluated in bulk formed part. The strain of probes on their sections was obtained using stereology by measurement of degree of grain boundary orientation which was converted to deformation using model of conversion of grain boundary orientation degree to deformation.
Authors and Affiliations
Maroš Martinkovič
Keywords
Related Articles
- EP ID EP103048
- DOI -
- Views 117
- Downloads 0
The impact of welding wire on the mechanical properties of welded joints
This paper presents results of the mechanical properties of Hardox 450 steel welded joints. These welded joints were made in accordance with welding procedure specifications (WPS), which was prepared and applied in the...
STUDY OF CALCIUM PHOSPHATE (DCPD) ELECTRODEPOSITION PROCESS ON THE Mg-3Al-1Zn MAGNESIUM ALLOY SURFACE
Evaluation of calcium phosphating process realized on the Mg-3Al-1Zn alloy surface after grinding was investigated by electrochemical tests supported by photodocumentation. The electrodeposition treatment was performed b...
CHARACTERIZATION OF PHASES IN SECONDARY AlZn10Si8Mg CAST ALLOY
Using recycled aluminium cast alloys is profitable in many aspects. Requiring only 5 % of the energy to produce secondary metal as compared to primary metal and generates only 5 % of the green house gas emissions, the re...
Influence of process parameters on torsional strength, impact toughness and hardness of dissimilar AISI 304 and AISI 1021 friction welded steels
In this present study an attempt was made to join austenitic stainless steel (AISI 304) with low alloy steel (AISI 1021) at different rotational speeds and at different axial pressures and then determining the strength o...
Static and dynamic tensile characteristics of DP600 steel sheets
Dynamic tensile testing of sheet steels is becoming more important. Experimental dynamic tensile technique is depending on the strain rate. Each serves for a specific range of strain rates and provides specific type of i...