STUDY ON PHYSICAL - MECHANICAL PROPERTIES OF ALKALI ACTIVATED MATERIALS BASED ON FLY ASH
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2012, Vol 19, Issue 4
Abstract
Alkali activated materials are relatively new materials, thanks to their good mechanical, physical, thermal properties and at the same time environmental friendliness, they could be widely adopted in different fields. The experiments, described in this article, are focused on the investigation of some basic mechanical-physical properties of alkali activated materials based on fly ash. For the following experiments were prepared two types of samples: in form of cubes and beams. On the cubes was tested compressive strength and on the beams – bending tensile strength and Young’s modulus of the material. It was also investigated the influence of water glass modulus, temperature of heat treatment on the final strength of the samples.
Authors and Affiliations
Olena Halas, Pavel Švanda
Keywords
Related Articles
- EP ID EP103604
- DOI -
- Views 116
- Downloads 0
Cyclic plastic behavior and fatigue life of AZ91 alloy in as-cast and ultrafine-grained state
Fatigue properties of magnesium alloy AZ91 in as-cast and in ultrafine-grained state prepared by equal channel angular pressing were investigated. The fatigue strength in the low-cycle fatigue region was found to be subs...
MICROSTRUCTURE EVOLUTION OF PURE TITANIUM DURING ECAP
The main goal of the presented paper was to describe deformation behaviour of the commercial purity titanium during the ECAP method. Attention was paid particularly on reached mechanical properties of above mentioned mat...
Thermal stability of magnesium alloy AZ91 prepared by severe plastic deformation
This paper deals with the thermal stability of ultrafine-grained alloy AZ91 prepared by means of ECAP (Equal Channel Angular Pressing) method. Annealing experiments were conducted isochronally for 30 minutes in the tempe...
CHOSEN PROPERTIES OF SANDWICH MATERIAL Ti-304 STAINLESS STEEL AFTER EXPLOSIVE WELDING
The work deals with evaluation of joint of stainless steel 304 SS (sheet) and commercially pure Ti both after welding explosion and followed-up annealing at 600°C/1.5h/air. The bonding line shows sinusoidal character wit...
Influence of mictrostructure features on the corrosion behaviourof AZ91 alloy in chloride media
The influence of the microstructure of as-cast AZ91 magnesium alloy, which applied to solution annealing treatment and ageing treatment respectively, was evaluated in terms of its corrosion behaviour in 0.1 M NaCl soluti...