MODELLING AND ANALYSIS OF ROTATING SYSTEMS WITH GAS FOIL BEARINGS UNDER TRANSIENT OPERATING CONDITIONS
Journal Title: Tribologia - Year 2017, Vol 272, Issue 2
Abstract
Gas foil bearings are on the cutting edge of bearing systems that spread worldwide. Although it is a common practice to apply such systems to high-speed fluid-flow machinery, their modelling and analysis still pose a number of problems. This article describes the methodology used to assess dynamic properties of a rotor-bearings system supported by foil bearings. Particularly close attention has been paid to the system operation in a transitional state during which a gaseous lubricating film is formed. The conception for the description of the rotor support characteristics was implemented in a computer program that is still under development. The approach that has been taken makes it possible to analyse the system properties throughout a whole range of rotational speeds. Another approach used in the past enabled for analyses of the dynamic performance of rotors, but only on the condition that bearing operation is correct (i.e. only fluid friction in bearing is present). The new model allows for much broader analyses of bearings operation, as confirmed by the obtained results. The article discusses exemplary results of analyses and shows a way one can assess the dynamic properties of rotating machinery equipped with foil bearings even when analysed under transient operating conditions.<br/><br/>
Authors and Affiliations
Grzegorz ŻYWICA, Małgorzata BOGULICZ, Paweł BAGIŃSKI
Wpływ kieszeni smarowych na zatarcie pary ciernej stal-brąz
Change of structure and wear resistance of P6M5 steel from processing in electrolyte plasma
A METHOD OF PRELOAD SELECTION FOR A SYSTEM OF ANGULAR CONTACT BALL BEARINGS DUE TO THE MOMENT OF FRICTION
Angular contact ball bearings are usually used in the situation when high stiffness of a bearing is demanded. However, a significant stiffness improvement can be achieved only after introducing a preload (“assembly clamp...
THE USE OF BIODEGRADABLE CUTTING FLUID FOR THIN AND HARD a-C:H AND TiAlN COATINGS
This paper presents results of tribological tests performed under lubricated friction conditions using a T-01M analyser. The lubricant was biodegradable cutting fluid containing a special-purpose additive – zinc aspartat...
ANALIZA WARTOŚCI TEMPERATURY TARCIA W STYKU STAL – MASA GLEBOWA W ZALEŻNOŚCI OD RODZAJU MATERIAŁU KONSTRUKCYJNEGO
W artykule przedstawiono badanie temperatury tarcia w styku masa glebowa-materiał. Do badań wytypowano próbki ze stali 38GSA napawanej elektrodą El-Hard 63 oraz stal Hardox 600. Eksperyment przeprowadzono w warunkach lab...