MODELLING AND TESTING OF DYNAMIC PROPERTIES OF C0-45 TURBOCHARGERS
Journal Title: Scientific Journals of Silesian University of Technology. Series Transport - Year 2017, Vol 97, Issue 97
Abstract
The paper presents modelling process and results of the bench tests of the C0-45, which is a turbocharger for heavy-duty diesel engines. For turbochargers like this, it is necessary to measure the level of vibration. This paper presents the test results for 115 turbochargers. Rotor speed during the tests varied between 25,000 and 42,000 rpm. Rotor speed during the tests on a C0-45 turbocharger varied within three ranges, i.e., Range I: n=25,00032,000 rpm and a=0.5g; Range II: n=33,00038,000 rpm and a=1.0g; Range III: n=39,00042,000 rpm and a=1.5g; (g=9.81m/s2). Measurement of vibrations was realized by a sensor located on the body of the turbocharger. Bench tests also included measurement of key charge parameters such as the amount of mass trapped, mean flow velocities, turbulence level, gas pressure, temperature and oil flow. The results are presented in the form of diagrams showing the amplitude of the acceleration function with regard to the rotor’s RPM. Research shows that using the correct parameters in construction and technological processes of assembly are very important for the effective functioning turbochargers.
Authors and Affiliations
Grzegorz BUDZIK, Aleksander MAZURKOW
Keywords
Related Articles
- EP ID EP327084
- DOI 10.20858/sjsutst.2017.97.2
- Views 78
- Downloads 0
NAUCZANIE PODSTAW KONSTRUKCJI MASZYN PO ANGIELSKU
W artykule przedstawiono doświadczenia (dobre i złe) z ponad 12-letniego okresu nauczania podstaw konstrukcji maszyn w języku angielskim zarówno dla studentów zagranicznych, jak i polskich. Największym problemem jest bra...
THE ANALYSE OF VIBRATIONS AFTER CHANGING SHAFT COUPLING IN DRIVE BELT CONVEYER
Within the complex dynamic systems such as power drive every part becomes a potential vibration driver with negative impact on the environment, maintenance and useful life of the mechanical systems. In addition, the purp...
NUMERICAL TESTS ON THE FLC SYSTEM OF A CRANE MODEL’S SLEWING MOVEMENT
In this paper, selected results from numerical tests on the influence of FLC settings upon the accuracy and quality of controlling, as well as the settling times, of a crane model’s slewing movement are presented.
ANALYSIS OF OPERATING PARAMETERS AND INDICATORS OF A COMPRESSION IGNITION ENGINE FUELLED WITH LPG
This article presents the possibilities for using alternative fuels to power vehicles equipped with compression ignition (CI) engines (diesel). Systems for using such fuels have been discussed. Detailed analysis and rese...
THE TEST PROGRAMME CONCERNING AIRCRAFT POSITIONING AND TRAFFIC MONITORING – PART I
The article presents results of the researches of the range to determine of the transmission’s data with using of the standard modems UHF Satellite on the transmission frequency of the 460 MHz and the regulating power 1...