Models and algorithms of expert procedures formation curriculum of the specialty
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2016, Vol 78, Issue 3
Abstract
A model of quantitative theory of planning and management processes of preparation of highly qualified specialists that meets modern requirements of society is developed. In the process of constructing this model, quantitative evaluation of ranking of academic disciplines at the formation of the curriculum training specialist is studied. The paper considers the process of forming a general list of academic disciplines to study questions concerning their inclusion in the curriculum. A quantitative assessment of each academic discipline with a common list in the form of local, absolute and relative rankings is formulated. Also the method of selection of subjects according to their categorization by rating, and regarding the similarity of the disciplines is offered. The paper considers the process of distribution of the academic hours between the disciplines, which complete the entire process of formation of the curriculum of specialist training according to specialty
Authors and Affiliations
А. О. Оvezgeldyyev, О. І. Prylypko
Keywords
Related Articles
- EP ID EP254259
- DOI -
- Views 102
- Downloads 0
The method of «blind» carrier frequency estimation of radio signals with linear digital modulation
Carrier frequency estimation in the conditions of a priori uncertainty of signal modulation and parameters is prerequisite for realization of frequency synchronization circuits in software-defined radio. To implement thi...
The results of experimental studies of the D-243 diesel with the addition of water to the air charge
Adding water to the fresh charge entering the internal combustion engine (ICE) allows to reduce the concentration of harmful substances in the exhaust gases, decrease thermal loads on engine parts, helps to reduce fuel c...
Research of the stress condition of cast billets blade chisel
Models of a drill bit and a mold were developed. Melted steel pouring process was studied. Residual stresses distributions for different sections of a blade bit were studied. The highest residual stresses were observed i...
Interaction of paint materials with a surface of natural stone
Anthropogenic activity causes air pollution and is one of the main factors responsible for the disintegration of archaeological and historical stone monuments. Over the past two centuries there has been a rapid increase...
Delivery to the method of visible pilopronic materials
The research considers the actual problem of determining the permeability of materials used for the production of personal protective equipment. Having analyzed the methods and instruments for determining the dust permea...