MODIFICATION OF THE SURFACE LAYER OF SINTERED DUPLEX STAINLESS STEELS THROUGH ALLOYING USING THE GTAW METHOD
Journal Title: Tribologia - Year 2018, Vol 278, Issue 2
Abstract
The demand for materials obtained using powder metallurgy (PM) is constantly increasing, especially on SDSSs, which are characterized by a two–phase structure consisting of ferrite and austenite. The main purpose of this study was to examine the effect of surface layer alloying with chromium carbide on the microstructure and tribological properties (e.g., hardness and wear resistance) of SDSSs. The multiphase sinters were prepared from two types of water–atomized steel powders: 316L and 409L. The technique of the APS method was used to deposit Cr3C2–NiAl powder on the SDSS surface. Electric arc (GTAW method) was used for surface alloying. Optical and scanning microscopy, X–ray phase analysis, and examinations of microhardness and coefficient of friction were performed in order to determine the microstructure and basic properties of SDSS after alloying. The surface alloying with Cr3C2 improves tribological properties of SDSSs such as hardness and the coefficient of friction.<br/><br/>
Authors and Affiliations
Barbara LISIECKA, Agata DUDEK
Keywords
Related Articles
- EP ID EP402705
- DOI 10.5604/01.3001.0012.6979
- Views 98
- Downloads 0
THE DAMAGE OF THE RACES OF LARGE BEARINGS
In this paper, some form of large bearing race damages and their causes are presented. Particular attention was paid to the single row four-point contact ball bearing races. The variations of the contact angle of the bal...
STANOWISKO DO BADANIA CIECZY MAGNETYCZNYCH PRACUJĄCYCH W TRYBIE ŚCISKANIA I ŚCINANIA
Zastosowanie cieczy magnetycznych w konstrukcji maszyn na skalę przemysłową jest faktem od ponad 20 lat. W szczególności ciecze magnetoreologiczne znalazły zastosowanie przede wszystkim w układach dyssypacji energii o st...
THE PROPERTIES OF CAST IRON SURFACE LAYERS MODIFIED BY LASER ABLATION MICROMACHINING
The article presents the results of model laboratory tests, including the measurement of temperature, friction force, and linear wear of the surface layer of samples made of grey cast iron sliding against a steel counter...
Właściwości tribologiczne materiałów kompozytowych zawierających węgiel szklisty
Przedmiotem badań był wpływ węgla szklistego jako dodatku pozwalającego kształtować właściwości tribologiczne w różnych grupach materiałów kompozytowych z osnową polimerową i metaliczną. Przeprowadzone badania wykazały,...
AlSi ALLOYS FOR MAGNETRON DEPOSITION OF THE COATINGS ON CAR EXHAUST MUFFERS – FORECAST OF TECHNOLOGICAL WEAR
In the production of car exhaust system parts, for protection against corrosion and high-temperature oxidation, alumina and AlSi alloy hot-dip coatings are currently especially effective. The authors of this study are co...