THE PROPERTIES OF CAST IRON SURFACE LAYERS MODIFIED BY LASER ABLATION MICROMACHINING
Journal Title: Tribologia - Year 2017, Vol 276, Issue 6
Abstract
The article presents the results of model laboratory tests, including the measurement of temperature, friction force, and linear wear of the surface layer of samples made of grey cast iron sliding against a steel counterpart. The surface layer of the cast iron specimen was modified using ablative laser micromachining in order to change its macro- and micro-geometry. To produce regular oil micro-reservoirs in a shape of micro-channels, an Nd: YAG laser (λ = 1064 nm, ƒ = 1 – 100 kHz, E = 50 J, P = 50W) with a special focusing system was used. Comparative studies included a grey cast iron specimen subjected to conventional mechanical machining and a specimen modified by ablative laser micromachining. 41Cr4 steel with a hardness of 50 HRC was used as a counterpart. Tribological tests were run in a pin-on-disk (T-11 tribometer) test set-up. The best results in the reduction of friction, temperature, and wear were obtained for samples with oil micro-reservoirs (made of ablative laser texturing) in a shape of micro-channels covering 5% of the entire tribological contact surface.
Authors and Affiliations
Wojciech NAPADŁEK, Adam WOŹNIAK, Czesław PAKOWSKI
THE IMPACT ANALYSIS OF THE EXPERIMENTAL PLAN ON THE MODEL OF ANTI-WEAR PROPERTIES
The article presented the results of analysis of models of the wear limiting load capacity that were developed based on the experimental data. The elements of friction contacts lubricated with mineral oil with additives...
Wpływ podstawowych parametrów konstrukcyjnych na straty mocy w zazębieniu walcowej przekładni zębatej
Sprawność przekładni zębatej w znaczącym stopniu zależy od strat mocy generowanych w zazębieniach, łożyskowaniach i uszczelnieniach. Wielkość tych strat jest uzależniona od tarcia w wymienionych węzłach przekładni określ...
A NEW TEST METHOD AND TESTING DEVICE FOR A HIGH TEMPERATURE TRIBOLOGICAL INVESTIGATION OF LUBRICANT PROPERTIES
The paper presents a testing device for the tribological investigation of the properties of greases designated to work under the conditions of elevated temperatures and low loads. The device was developed in the framewor...
WPŁYW STARZENIA KLIMATYCZNEGO NA KINETYKĘ ZUŻYWANIA EROZYJNEGO NANOPOWŁOK POLIMEROWYCH
W artykule przedstawiono wyniki badań odporności erozyjnej trójwarstwowych epoksydowo-poliuretanowych systemów powłokowych różniących się składem poliuretanowej warstwy nawierzchniowej. Do modyfikacji warstwy nawierzchni...
THE INFLUENCE OF ISOTHERMAL OXIDATION PARAMETERS ON THE TRIBOLOGICAL PROPERTIES OF TITANIUM
The paper presents the results of tests concerning the tribological properties of titanium Grade 2 subjected to thermal oxidation at a temperature of 600°C and 700°C for 72 hours. Morphology of the obtained oxide scale w...