Monitoring of the Rolling Mill Vibration
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2009, Vol 32, Issue 2
Abstract
These researches show the influence of mill vibration on the thickness profile of the stainless steel sheet. The alloy elements like Ni and Cr inside the stainless steel could amplify the rolling mill vibration and determine severe damages for rolling sheet. These damages consist in variation of thickness on the length of strip. We made recordings of vibrations during the rolling process and we propose an integrate system for vibration monitoring.
Authors and Affiliations
Stefan DRAGOMIR, Georgeta DRAGOMIR, Marian BORDEI
Keywords
Related Articles
- EP ID EP655769
- DOI -
- Views 73
- Downloads 0
Mathematical Modeling of the Heat Treatment Processes Applied to Alloy Al-Zn-Mg-Cu-4.5% Zn Used in Aeronautics
This paper presents mathematical modeling based on the regression analysis method by active experiment of a thermal treatment process applied to an alloy belonging to Al-Zn system, which finds application in aeronautics....
The Protective Behaviour of Titanium Nitride Coatings
The experiments conducted to obtain a thin layer of nitride through the vapour chemical deposition method have followed an original path to obtain TiN directly in the working room thus avoiding the import of these hazard...
Research on the Influence of the Complementary Phase Percentage on the Properties of Copper - Based Composites
The article presents the method to obtain copper matrix composite with CuAl-Fe alloy particles as complementary phase. The samples were obtained by powder metallurgy methods using different percentages of complementary p...
Influence of Cooling Oil on the Surface Quality of the Rolled Strip
The excess of emulsion used in the lamination process leads to the formation of drops which in the annealing process forms spots of burned emulsion. It was also shown to cause formation areas with high carbon concentrati...
Aspects Regarding the Widia Plates Behaviour Covered With Tin During the Cutting Process
The microscopic property that depends on the interfacial structure and on the tension to which the interface is submitted is called adherence. The strong connection in the interfacial area, low tension gradients, the abs...