The Influence of Cold Rolling on the Microstructure for Drawing Steels
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2007, Vol 30, Issue 2
Abstract
The paper presents the structural changes that appeared in steel for deep drawing, as a result of cold rolling and of recrystallization thermal treatment. The research was conducted on samples taken from the rolled strap, treated and rerolled after the present technology in Arcelor Mittal. For comparison samples sampled from the steel strap before cold deforming (hot rolled) were used as blank tests. The thermal processing was done under industrial conditions in bell furnace. For the chosen steel the critical deformation degree was around the value of 6.5%.
Authors and Affiliations
Florentina POTECAŞU, Octavian POTECAŞU, Elena DRUGESCU, Petrică Alexandru, Miltiade ISTRATE, Doru HANGANU
Keywords
Related Articles
- EP ID EP661014
- DOI -
- Views 56
- Downloads 0
Behavior of Some Stainless Nitrided Austenite Steel Types to Corrosion and Abrasion
By nitriding, stainless austenite steel types can become surface hardened. Hardness can be greater at more than 1000 HV005 when the composition layer made of complex nitrides is obtained and more reduced till 500 HV005 w...
Structure Characterization of Ca/Ba, Ca-FeSi Inoculated, Low Sulphur, Electric Melted, Thin Wall Grey Iron Castings
Much of the base iron in grey iron foundries is electrically melted in an acid lined induction furnace. The performance of the induction furnace allows superheating above 1500 oC, which is appropriate for thin wall casti...
Monitoring of the Rolling Mill Vibration
These researches show the influence of mill vibration on the thickness profile of the stainless steel sheet. The alloy elements like Ni and Cr inside the stainless steel could amplify the rolling mill vibration and dete...
Low Potential Heat Recovery Using Heat Pumps
This paper presents a study on the possibility of recovering low thermal potential heat from the cooling technological water of industrial processes. The analysed solution consists in the use of a heat pump which would s...
Correlation Between the Properties of Old Slags and the Recycling Solutions
The blast furnace and basic oxygen furnace route of steel making (from iron ores and coke to steel) or the so called integrated steel production generates simultaneously solid waste products. The slag is predominant, con...