MULTI RESPONSE OPTIMIZATION OF EDM PROCESS PARAMETERS FOR INCONEL X-750 USING MOORA
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2019, Vol 42, Issue 2
Abstract
Electrical discharge machining (EDM) is used extensively to machine hard to cut materials like nickel, titanium and super alloys with higher dimensional accuracy and surface finish. In this present study, a multi response optimization on the basis of ratio analysis (MOORA) is proposed for finding optimum process parameter of Electrical Discharge machining (EDM) during machining of Inconel X-750 material which is used mostly in thermal erosion process like nuclear plants, aerospace industry. In this study, response surface methodology (RSM) with Box-Behnken approach has been utilized for selecting the appropriate process parameters by using three level four factor (discharge current (Ip), voltage (V), pulse on time (Ton) and pulse off time (Toff)) using tungsten copper electrode (W-Cu). The machining responses considered are material removal rate (MRR), surface roughness (SR) and tool wear rate (TWR). The satisfactoriness of developed mathematical model has been tested with the use of analysis of variance (ANOVA). Further mathematical equations are generated using the statistical software MINITAB 17. The experimental data used for adequate regression model to optimize the process using MOORA. Further the surface characteristics of the machined surface are identified using scanning electron microscope (SEM) and elements with their peak values are revealed with EDX analysis.
Authors and Affiliations
Shaik Khadar Basha, M. V. Jagannadha Raju, Murahari Kolli
A STUDY ON THE FACTORS AFFECTING THE FLARE OF THE WELD WHEN WELDING THE STEEL WIRE
In this study, an equation for adjusting the parameters affecting the flare of the weld on the welding product was established. Based on the empirical research results, the factors affecting welding flux after using bend...
PROPOSAL OF SOME ADVANCED TECHNOLOGY METHODS IN THE ASSEMBLY OF THE SHAFT SYSTEM – MAIN ENGINE ON THE SMALL CARGO SHIPS
In recent years, along with the strong development of science and technology, many new construction methods have been applied in the shipbuilding industry for high technical efficiency, shortening construction time and r...
ENERGY AND EXERGY ANALYSIS OF A SOLAR PHOTOVOLTAIC PERFORMANCE IN BAGHDAD
Photovoltaic modules usually generate electricity from a specific range of light frequencies and cannot cover the whole solar range of infrared, ultraviolet and diffused light. Hence, much of the striking sunlight energy...
THE IMPACT OF USING BIODIESEL PREPARED FROM WASTE SUNFLOWER OIL & IRAQI CONVENTIONAL DIESEL ON COMPRESSION IGNITION ENGINE PERFORMANCE AND EMISSIONS
The biodiesel fuel is a future fuel due to has oxygen in its chemical composition enhances thereby the chemical reaction process during combustion. The waste sunflower oil is selected for biodiesel preparation because it...
MECHANICAL CHARACTERIZATION AND COMPARATIVE STUDY ON POLYESTER COMPOSITE LAMINATES REINFORCED WITH DIFFERENT BIO WASTE MATERIALS
The composites are the promising materials of this century, amongst that different types of polymeric matrix reinforced with different materials found application in many of the service industries. In most of the cases t...