Research of the effectiveness of mechanical testing methods with analysis of features of destructions and temperature effects
Journal Title: Frattura ed Integrità Strutturale - Year 2013, Vol 7, Issue 24
Abstract
In this paper is carried out the comparative analysis of effectiveness of test methods of determination of stiffness and strength properties of highly filled unidirectional fiberglass (Direct "E" roving 0.7 - orthophthalic polyester resin 0.3) via tensile testing along the reinforcement and three-point bending testing at several bases. The necessity of deviation from standard procedures is substantiated. Deformation and failure features of the material under quasi-static loading, as well as at low and high temperatures, are shown.
Authors and Affiliations
A. V. Babushkin, D. S. Lobanov, I. D. Morev
Keywords
Related Articles
- EP ID EP98467
- DOI 10.3221/IGF-ESIS.24.09
- Views 99
- Downloads 0
Studio del danneggiamento mediante tomografia in luce del sincrotrone: impatto di un cono d’ombra sulla qualità finale delle ricostruzioni
Un’accurata osservazione della geometria tridimensionale di cricche e difetti è necessaria per lo studio dei meccanismi alla base del processo di danneggiamento. I metodi convenzionali utilizzati a questo scopo sono dist...
Structural mechanisms of formation of adiabatic shear bands
The paper focuses on the experimental and theoretical study of plastic deformation instability and localization in materials subjected to dynamic loading and high-velocity perforation. We investigate the behavior...
Research on parameters optimization of bilateral ring gear blank-holder in thick-plate fine blanking
To compensate for the poor quality of thick-plate blanking parts in cross-section, this paper suggests using the optimizing bilateral ring gear holder parameters to increase burnish zone and improve cutting preci...
Failure prediction of T-peel adhesive joints by different cohesive laws and modelling approaches
In this work, Cohesive Zone Modelling (CZM) was used to simulate failure of T-peel bonded joints with 1.5mm thick adherends, respectively, bonded toghether with Loctite Multibond 330 adhesive. The fracture toughness and...
Combined lock-in thermography and heat flow measurements for analysing heat dissipation during fatigue crack propagation
During fatigue crack propagation experiments with constant force as well as constant stress intensity lock in thermography and heat flow measurements with a new developed peltier sensor have been performed. W...