New approach in form cutter profiling
Journal Title: Журнал інженерних наук - Year 2016, Vol 3, Issue 1
Abstract
The universal algorithm, independent of geometric parameters of detail and required cutter type, becomes relevant within using modern computing means. Following this argument the universal mathematical model, which generalizes formerly known approaches in the designing of different cutter types is offered. The initial data for calculation are the number of points on the detail surface, the values of rake and clearance angles, parameters of detail in each point of the surface and the axial distances of these points from the flat end chosen as the datum. The cutter type has no influence on the calculation algorithm. 3-D modeling is the easiest way to do graphic profiling. Profiling process is based on determining the initial tool surface and characteristics. The comparison of the results of analytical and graphic profiling of form cutter shows the full match in all points, which confirms the adequacy of the mathematical model and the graphic profiling algorithm.
Authors and Affiliations
S. Shvets
Keywords
Related Articles
- EP ID EP241687
- DOI -
- Views 63
- Downloads 0
The decrease in technogenic load on the environment during the process of absorption of ammonia in soda industry
The article studies the effectiveness of implementation of existing equipment of soda production absorbers for ammonia cleaning from gas emissions. It identifies the major sources of ammonia emissions in the soda ash pro...
Implementation of Efficient Artificial Neural Network Data Fusion Classification Technique for Induction Motor Fault Detection
Reliability measurement and estimation of an industrial system is a difficult and essential problematic task for control engineers. In this context reliability can be described as the probability that machine network wil...
Research of Mechanical Properties of Thermite Material on the Basis of Steel Dross
Important direction in the development of technologies for the recycling of wastes of industrial productions is inclination on the use energy saving technologies. The article deals with general aspects of methods of util...
Modelling of Separation and Air Classification Processes of Aerodisperse Systems in the Shelving Device
The following paper considers the process of classification of polydisperse free-flowing material according to granulometric composition using a gravitational air classificator. There were considered the problems of the...
Stress-strain state of the lower traverse of the hydraulic press
In the present article the stress-strain state of the lower traverse of the central ejector of the hydraulic press for manufacturing large-sized plastic products has been investigated by using finite element analysis. It...