Numerical Determination of The Probability of Failure of a Bent Steel Rod
Journal Title: Металлические конструкции - Year 2017, Vol 23, Issue 1
Abstract
In this paper, we consider three different methods for calculating the probability of failure (the method of two moments, statistical tests and Monte Carlo) of the rod element. As an example, a calculation is made for a statically determinate single-span beam loaded with snow load. As initial stochastic values, the cross-sectional area, snow load and the yield point of the construction material were considered. The analysis of the obtained results of failure probability is made and recommendations are made on the applicability of the methods considered.
Authors and Affiliations
Volodymyr Mushchanov, Igor Garanzha, Anatoliy Orzhekovskiy
Keywords
Related Articles
- EP ID EP448722
- DOI -
- Views 108
- Downloads 0
Qualitative Parameters of Guyed Chimney Interaction with Anchor Foundations
The effect of ground deformation of anchor foundation on stresses and strains in steelworks is dealt with in the paper including guyed steel chimney. The horizontal deformations of ground are modeled by inducing differen...
Full Factor Experiment for Optimization of Geometric Parameters of the Glass-Furnace Arches
The article considers the conduct of a full factorial experiment. The hypothesis of the reproducibility of the experiments was verified, which confirmed the fact that there was no need to conduct a repeat experiment. The...
A Determination of the Residual Life of Steel Bin of Coke-Screening Station Taking into Account Operating Corrosive Damages
The article presents the results of analysis of the tensely-deformed state of a steel bunker for storage of coke. The calculation is performed according to engineering procedure and using software complex LIRA-SAPR 2013....
The Choice of Rational Parameters of Frames of Variable Rigidity, While Using Genetic Algorithm Optimization
The article deals with the use of the genetic optimization algorithm for selecting rational parameters of variable-rigidity metal frames (variable cross-section). An example of the simplest genetic algorithm on the block...
The Analysis of the Stress-Strain State of the Optimal Corner Dead-end Support of Overhead Power Transmission Line 110 kV
The analysis of the stress-strain state of dead-end OPTL support which is considered as spatial repeatedly statically indefinable through system with rigid joints is performed. The technique and results of calculation of...