NUMERICAL SIMULATION OF YIELDING SUPPORTS IN THE SHAPE OF ANNULAR TUBES UNDER STATIC AND SHORT-TERM DYNAMIC LOADING
Journal Title: International Journal for Computational Civil and Structural Engineering - Year 2017, Vol 13, Issue 4
Abstract
Occurrence of extreme man-made impacts on buildings and structures has become frequent lately as a consequence of condensed explosives or explosive combustion of gas- vapor or air-fuel mixtures. Such accidents involve large human and economic losses, and their prevention methods are not always effective and reasonable. The given research aims at studying the way of enhancing explosion safety of building structures by means of yielding supports. The paper presents results of numerical studies (finite element, 3D nonlinear) of strength and deformability of yielding supports in the shape of annular tubes under static and short-term dynamic loading. The degree of influence of yielding supports was assessed taking into account three peculiar stages of deformation: elastic; elasto-plastic; elasto-plastic with hardening. The methodology for numerical studies performance was described. It was established that rigidity of yielding supports influences significantly their stress-strain state. The research determined that with increase of deformable elements rigidity dependency between load and deformation of yielding supports in elastic and plastic stages have linear character. Significant reduction of dynamic response and increase of deformation time of yielding supports was observed by increasing the plastic component. Therefore it allows assuming on possibility of their application as supporting units in reinforced concrete constructions
Authors and Affiliations
Oleg G. Kumpyak, Nikita V. Mescheulov
Keywords
Related Articles
- EP ID EP576836
- DOI 10.22337/2587-9618-2017-13-4-103-113
- Views 67
- Downloads 0
ЧИСЛЕННОЕ МОДЕЛИРОВАНИЕ ПОДАТЛИВЫХ ОПОР В ВИДЕ ТРУБ КОЛЬЦЕВОГО СЕЧЕНИЯ ПРИ СТАТИЧЕСКОМ И КРАТКОВРЕМЕННОМ ДИНАМИЧЕСКОМ НАГРУЖЕНИИ
В последнее время участились случаи экстремальных техногенных воздействий на здания и сооружения, например, вследствие взрыва конденсированных взрывчатых веществ либо взрывного горения газо-, паро- или пылевоздушных смес...
ИСПОЛЬЗОВАНИЕ ПРОГРАММНОГО КОМПЛЕКСА ЛИРА-САПР ПРИ СОСТАВЛЕНИИ РАСЧЕТНЫХ СХЕМ РЕКОНСТРУИРУЕМЫХ ЗДАНИЙ
Рассматривается методика моделирования зданий в эксплуатационной стадии с учетом изменяющейся конструктивной схемы в процессе реконструкции. Предлагается алгоритм расчета конструкций в линейной и нелинейной постановке с...
ВЕЙВЛЕТ-РЕАЛИЗАЦИЯ ДИСКРЕТНО-КОНТИНУАЛЬНОГО МЕТОДА КОНЕЧНЫХ ЭЛЕМЕНТОВ ДЛЯ РАСЧЕТА ПЛИТ С ИСПОЛЬЗОВАНИЕМ МАСШТАБИРУЮЩИХ ФУНКЦИЙ ДОБЕШИ
Настоящая статья посвящена одной специальной версии вейвлет-реализации дискретноконтинуального метода конечных элементов для расчета плитных конструкций. В рамках указанной версии используются масштабирующие функции Доб...
SEARCHING SHEAR FORCES FLOWS FOR AN ARBITRARY CROSS-SECTION OF A THIN-WALLED BAR: DEVELOPMENT OF NUMERICAL ALGORITHM BASED ON THE GRAPH THEORY
Searching problem of shear stresses on outside longitudinal edges of an arbitrary cross-section (including open-closed multi-contour cross-sections) of a thin-walled bar subjected to the general load case has been consid...
TWO-STAGE GRID METHOD OF SOLUTION OF BOUNDARY PROBLEMS OF STRUCTURAL MECHANICS WITH THE USE OF DISCRETE HAAR BASIS
The distinctive paper is devoted to development of two-stage numerical method. At the first stage, the discrete problem is solved on a coarse grid, where the number of nodes in each direction is the same and is a pow-er...