Optimization of Thermal Processing Parameters of a High Strength Aluminum Alloy
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2015, Vol 38, Issue 3
Abstract
The work shows a calculation meant to optimize the thermal processing parameters (time and temperature) of a high strength aluminum alloy. The optimization calculation has been done by gradient method which involves multistep (iteration) calculation of thermal processing parameters in which the values of the mechanical properties meet certain restrictions imposed. Identifying the most economic variants of heat treatment of those resulting from the application of gradient method was carried out by performing calculations of heat balance of the heat-treatment oven.
Authors and Affiliations
Marian-Iulian NEACȘU, Doru HANGANU
Keywords
Related Articles
- EP ID EP581342
- DOI -
- Views 82
- Downloads 0
Surface Tension of Liquid Copper in Dilute Oxygen Concentrations
The studies of this paper regarding the influence of low oxygen contents on the liquid copper surface tension had as base „sessile drop” method and the determination of the oxygen content using calculation ratio where pa...
Influence on Reduction Scheme Hardness Cold Rolled Strip Mark Steel ST 12
The paper presents the results of the research on the influence of the evolution hardness scheme rolled steel, for the cold-rolled strip steel St 12. St 12 is intended for the manufacture of cold rolled strip stamping pr...
Optimization of Thermomechanical Processing of Some Aluminum Alloys by Dimensional Interpolation Method Using the Matlab
This paper presents results of research on optimization of thermomechanical treatment applied to an alloy of the Al-Zn-Mg-Cu system, used in the aviation industry.Optimizing thermomechanical treatment process is based on...
Magnetical Properties of Silicon Steels Used for Electrotechnical Industries
This paper-work shows the laboratory experiments achieved on more silicon steel plates, where the magnetic ranges were spot- lighted by particular technical requirements. On the same plates the texture analyses were made...
Calculation of the Deposited Layer Thickness Through Side Injection of Powder Using CO2 Laser
The paper presents a simplified theoretical model for estimating the operating parameters of the laser deposition by injecting the powder into the metal bath. The study considered the influence of the powder particles on...