Perspective directions to increase heat tolerance of silicone carbid and molibdenum disilicide based materials
Journal Title: Вісник Тернопільського національного технічного університету - Year 2016, Vol 82, Issue 2
Abstract
Perspective directions to increase heat-tolerance of silicon carbide and molybdenum disilicide ceramic electric heaters have been outlined based on literary data analysis and research results. The producers of electric heaters solve such complex problem in various ways. The best way is improving ceramic materials production technology, in particular, use of initial materials with the least amount of harmful admixtures. Very often admixtures which get into the products during the manufacturing process influence physical and chemical properties of carbide silicon ceramic materials. They are located on the margins of silicon carbide grains and reduce the effective thermal conductivity of the ceramics, and change its ultimate electrical resistance due to the formation of a conductive grid at grain boundaries. Partial purification of the initial components from metal and other impurities significantly improves the electrical parameters of electric heaters.
Authors and Affiliations
Vasyl Kovbashyn, Ihor Bochar
Keywords
Related Articles
- EP ID EP257634
- DOI -
- Views 61
- Downloads 0
Optimization of the sports ground illuminating devices distribution
Requirements to the sports ground illumination have been analyzed. As the result of the analysis of the latest publications dealing with the optimization of the illumination-technological parameters of the sports grounds...
Ways to save fuel and energy resources in daily graft
Through experience it has been set the influence of various types of heat sources (gas stove for 4 burners, induction cooktop and electric kettle), volumes of water, the diameter of gas stove burners (55 mm, 75 mm, 100 m...
Elastic deformations and anomalously high cutting ability of a polymer solution jet
The article to determine peculiarities of macromolecule deformation behavior under conditions of a jet-shaping head that would allow to solve the issue related to the mechanism of increasing water-jet cutting power with...
Effect of binder with nano Ni on mechanicalproperties of TiC based hard alloys
Titanium carbide based hard alloys with nickel-chromium binder possess high hardness, wear and heat resistance. In order to improve physical and mechanical properties of alloys the polycarbide basis TiC-5WC-5NbC and Ni (...
Solution of the non-axisymmetric quasistatic thermoelasticity problem for multilayer cylinder with identical Lamé coefficients
The non-axisymmetric thermoelastisity state of the multilayer unlimited hollow cylinder with the identical Lame coefficients of layers under the action of internal and surface heat sources and non-uniform distribution of...