Pick and Place Robotic Arm Implementation Using Arduino
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2017, Vol 12, Issue 2
Abstract
A robotic arm is designed using arduino to pick and place the objects via user commands. It will pick and place an object from source to destination safely. The soft catching gripper used in the arm will not apply any extra pressure on the objects. The robot is controlled using android based smart phones through Bluetooth. Based on the commands given by the user the robot moves accordingly. At the receiver end there are four motors interfaced with the micro controller. Two for the vehicle movement and the remaining two are for arm and gripper movement. Blue control application is used for the controlling of robot.
Authors and Affiliations
Ashly Baby, Chinnu Augustine, Maria George
Keywords
Related Articles
- EP ID EP387111
- DOI 10.9790/1676-1202033841.
- Views 124
- Downloads 0
Analysis of Low Power Multi-core Embedded Management for Energy Harvesting
This paper presents an Intelligent Power management system which primarily focuses on power harvesting and low power consumption management and controlling of multi-core embedded system. Now, such multi-core embedded sys...
A Novel Approach to Build a Gated Integrator for HighResolution Energy Spectroscopy Systems
A gated integrator (GI) is to solve the ballistic deficit problem by integrating the signal until all the charge is collected from the detector. With the development of radioactive ion beam physics, heavy-charged particl...
Power Quality Investigate by Using the Varying of Voltage Parameter
To evaluate the power quality of a power system which is necessary to monitor the power quality of the power supply environment. The purpose of monitoring is mainly to determine power quality problems or to assess power...
Comparison Analysis of Zeta PFC Converter to Improve Power Quality Improvement by PI Controller, Hysteresis Controller and Fuzzy Logic Controller for Speed Control of Induction Motor
This project “comparison analysis of ZETA PFC converter to improve power quality improvement by PI Controller, Hysteresis controller and Fuzzy logic controller for speed control of a Induction Motor”is composed of anisol...
A Solar-Photovoltaic Grid Interface Systemusing Smc Based On Lyapunov Function
A sliding mode control technique (SMC) is used for achieving maximum power point tracking (MPPT) control of solar-PV array. The Lyapunov function-based control technique is designed and developed for the DC-AC inverter t...