Polyurethane Production from Waste Bale Fibers
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2017, Vol 5, Issue 4
Abstract
Nowadays, the methods of eliminating the pollution from wastes of the materials produced as much as the production methods are important. This requires efficiently use of sources economically and ecologically. Polyester based polymers, which is one of the most important consumed plastic materials in the world, have lots of number of recycling methods. Basically it is called chemical and physical recycling. Chemical recycle methods include glycolysis, aminolysis, methanolysis, hydrolysis and etc.. In this study aromatic polyester polyols produced from bale fiber wastes via glycolysis method. Zinc Acetate used as a catalysts and diethylene glycol used for the glycolysis reaction and moiety of glycol investigated as an experimental parameter. Polyurethane material produced via obtained polyol and TDI (Toluene di Isocyanate) reaction. Obtained polyurethane material investigated via FTIR and TGA and compared with the commercial polyurethane. As a result, it has been decided that glycolysis is usable and applicable method for the waste bale fibers.
Authors and Affiliations
İbrahim BİLİCİ
Keywords
Related Articles
- EP ID EP489244
- DOI 10.29109/http-gujsc-gazi-edu-tr.305317
- Views 70
- Downloads 0
Z in ’Sequential Model’ Spin Analysis for New Adjustment
In the e + e multiplier, the spin analysis for the Z boz new tuning boson was studied. In the Sequential Model, a normalized cross-section of different spin states was investigated. This study shows that the new setting...
Design of Parallel Analog to Digital Converter Based on Darlington CMOS Inverter
This article presents a 4-bit parallel analog-to-digital converter was designed by using Darlington CMOS Inverter which is operated in accordance with CMOS threshold voltage. Thus, there is no need to use resistance arra...
The Effect of Heat Treatments on Alloying of Pre-mixed Al + 4.5 wt. % Cu Powders
In this study, 4.5 wt. % Cu powder was added to Al powder and mixed for 45 minutes to produce premixed metal powders. Premixed powders were compacted by cold pressing at 20 MPa. After that these samples were pressed at 5...
Contractors in the Construction Sector and R & D
Innovation is widely regarded as one of the key issues of national economic growth and competitiveness. Measurement of innovation and implementing it as a corporate culture is considered necessary as it is one of the key...
Wall Solar System Working Principle and Applicability in Turkey
Solar wall is an auxiliary system for heating buildings. It is used to preheat the air passing through it so as to reduce the load of heating system of the building. It makes the heating system economically more efficien...