PROBLEMS OF THE SURFACE LAYER TECHNOLOGICAL FORMING IN THE ASPECT OF THE SCUFFING PERFORMANCE. PART II: THE TOPOLOGICAL APPROACH
Journal Title: Tribologia - Year 2015, Vol 264, Issue 6
Abstract
The proposition of the topological approach to the technological creation of the surface layer’s scuffing performance is presented in this article. It was recognized, based on the cycle of experiments, that the scuffing performance depends on the interaction between rheological, physicalchemical, and morphological properties of the surface layer. Some morphological scuffing invariants (parameters developing to the similar lever at the time of the process initiation) were experimentally discovered. Motifs, their characteristics, and the Vvv (void volume of valleys) parameter were selected as optimal, morphological invariants. The surface polarity was considered as the key physical-chemical surface’s property. In the case of the rheological surface’s feature, residual stresses were stated as the best representative. Taking into considerations the possibility of all these parameters being created, it was proposed the concept of “pVt” limits (pressure x velocity x time) as the characteristic allowing the prediction or event control of the timing of the scuffing initiation.
Authors and Affiliations
Łukasz WOJCIECHOWSKI
Keywords
Related Articles
- EP ID EP255881
- DOI -
- Views 47
- Downloads 0
Badania procesu tarcia kinetycznego w ciernych skojarzeniach żeliwo-stal
W artykule przedstawiono przeprowadzone badania tribologiczne wybranego skojarzenia żeliwo–stal. Zaprezentowano w tym celu zbudowane stanowisko badawcze oraz jego oprzyrządowanie pomiarowe. Scharakteryzowano sposób przyg...
PROPERTIES OF ELECTRODEPOSITED Ni-Mo COATINGS
Mechanical and tribological properties of electrodeposited Ni-Mo coating were studied. Coatings of 30 μm thickness were deposited under different cathodic current densities 0.5–5 A/dm2 on steel disc substrates. Microhard...
CHANGES OF SURFACE LAYER PROPERTIES IN GEAR TEETH AFTER SHOT PEENING
Considering the phenomenon during teeth cooperation in a toothed gear and produced loads within the macro and micro areas of contact surface, one should be paying attention to the type and condition of the surface layer....
Ustalanie receptury kompozytowego ciernego materiału hamulcowego
Stosowane obecnie kompozytowe materiały cierne zawierają ponad 20 składników. Wyeliminowano z nich azbest i ołów. W nowych recepturach nie używa się też rtęci, kadmu, antymonu i chromu VI. Materiały cierne projektowane s...
PORÓWNANIE ZUŻYCIA DŁUT PŁUGA WYKONANYCH Z RÓŻNYCH MATERIAŁÓW ORAZ PO NAPAWANIU
W pracy przedstawiono wyniki ilościowe zużycia masowego dłut pługa pracujących w gruncie, wykonanych z różnych gatunków stali oraz poddanych napawaniu powierzchniowemu. Badania przeprowadzono w rzeczywistych warunkach po...