Profilometric Analysis of Worn Surface of Bronze, Iron and Iron Composite Samples, by Pin-on-Disk Method
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2013, Vol 36, Issue 2
Abstract
In this study are presented the results of profilometric analysis for the wear of bronze materials, cast iron and composite materials. These materials were tested under dry wear conditions, using "pin-on-disk" method on a UMT-2 tribotester at a room temperature and relative humidity of 30-45%. The tests were carried out with load of 30, 40 and 60N at a linear speed of 0.815 m/s. The resulted traces of wear were examined with a Surtonic 3 + profilometer that has Talyprof software installed on, trademarks of TAYLOR HOBSON (United Kingdom) company. The obtained results allowed for a tribological analysis of the materials and their classification from the tribological point of view.
Authors and Affiliations
Virgil ILIUŢĂ, Luminiţa CIUPAGEA (COTEŢ), Gabriel ANDREI, Minodora RÎPĂ
Keywords
Related Articles
- EP ID EP596162
- DOI -
- Views 66
- Downloads 0
Surface Hardening of 40Cr10 Steel after Short Time Nitriding in Fluidized Bed
The paper is based by nitriding in fluidized bed experiments over laboratory plant. Fluidization applications are characterized by high values of mass and heat transfer coefficients. For experiments were used 40Cr10 (Rom...
On the Kinetics of Sol Gel Al:ZnO Thin Films Crystallization on Silicon Substrate
Recently, there is a growing interest in applying ZnO thin films on silicon buffer substrates for p-n junction devices, optical wave guide, etc. A sol gel process is very attractive technique for obtaining oxide thin fil...
The Evolution of the Characteristics of Mechanical Resistance for the Nitro-Carburrized Treated Steel, after Thermo-Magnetic Treatment
The aim of the research was to study the evolution of the characteristics of mechanical resistance for one type of steel. The material was subjected to the thermo-chemical (nitro-carburized treatment in plasma) treatment...
Superior Valorisation of the Aluminium Scraps for Obtaining Complex Aluminium Master Alloys Used in Advanced Refining of Steels
The research about aluminium scraps valorisation to obtain master alloys with reactive elements (Al, Mn, Si) used for special steels refining is presented in this paper. By this way the recycling of aluminium scraps lead...
On the Constitutive Equation of a Low Carbon Steel
The paper shows the results of the researches concerning the equation of deformation behavior of low carbon steel. The behavior law is established starting from the experimental torsion moment. The composed constitutive...